AudiWorld Forums

 
Page 1 of 20
1
2
3
11
Last »
Search: Posts Made By: squidix9
Showing results 1 to 25 of 496
Search took 0.77 seconds.
Forum: Audi allroad
08-11-2019, 01:28 PM
Replies: 2
Views: 759
Posted By squidix9

Yes

I always use O2 safe sealant in the corners where the gasket bends up and over the cam. Depending on the condition of the surface I may also run a tiny head over the cam too if it's rough.
Forum: Audi allroad
07-04-2019, 09:28 AM
Replies: 20
Views: 4,961
Posted By squidix9

Green Loctite

Sort of OT, but I wouldn't recommend green Loctite. My own personal opinion. To use it properly it should also be used with the primer. It's anaerobic and the primer helps fill in any microscopic...
Forum: Audi allroad
07-04-2019, 07:55 AM
Replies: 0
Views: 828
Posted By squidix9

I'm back

Last I was here was a few months ago saying hi and searching for parts. Then I disappeared. Well, I am back. An unexpected hospital stay put an immediate grinding halt on everything.

Thankfully, I...
Forum: Audi 90 / 80 / Coupe quattro / Cabriolet
05-06-2019, 04:44 AM
Replies: 6
Views: 2,052
Posted By squidix9

1987,5 CGT (NG) parts?

*
Forum: A4 (B8 Platform) Discussion
05-05-2019, 07:31 AM
Replies: 5
Views: 22,156
Posted By squidix9

^^ I was just going to ask the same question

Does the steering angle change when you turn the wheel?
Forum: A4 (B8 Platform) Discussion
05-05-2019, 07:26 AM
Replies: 4
Views: 21,536
Posted By squidix9

You're headed to a tranny shop or the dealer

https://cimg2.ibsrv.net/gimg/www.audiworld.com-vbulletin/1080x1920/screenshot_20190505_112047_chrome_2aff6040e5eddaace698523a40dec32fe66b0f3d.jpg
Number 3 is the parking interlock module. There's...
Forum: A4 (B8 Platform) Discussion
05-05-2019, 07:04 AM
Replies: 4
Views: 1,094
Posted By squidix9

Milltek?

*
Forum: A4 (B8 Platform) Discussion
05-05-2019, 07:01 AM
Replies: 7
Views: 11,524
Posted By squidix9

MIL's are only set for group 0 PID's

You may not have a MIL lit and still have a boatload of codes
Forum: A4 (B8 Platform) Discussion
05-05-2019, 06:52 AM
Replies: 1
Views: 521
Posted By squidix9

Good safe car for that

My daughter will be 16 in September so we're keeping our eyes open for something for her. I am highly biased towards Audi. I bought a BMW xdrive for this past Winter and had planned on passing it to...
Forum: A4 (B8 Platform) Discussion
05-05-2019, 06:19 AM
Replies: 1
Views: 3,308
Posted By squidix9

No worries

I replace them all the time. Just replace the motor/arms. No special coding or OBD functions necessary. The only issue is if the arms are stuck, it's a tight fit and they my be hard to cone out. Also...
Forum: A4 (B8 Platform) Discussion
05-04-2019, 04:35 PM
Replies: 0
Views: 1,129
Posted By squidix9

2012 CAEB oil consumption

Anyone have luck getting Audi to cover a 2012 under the 8/80 for oil consumption? I know the suit only covered up to 2011, but it's also supposed to cover all CAEB's.
Forum: A6 / S6 (C6 Platform) Discussion
04-26-2014, 09:36 PM
Replies: 3
Views: 10,085
Posted By squidix9

The reservoir is in the front of the left fender...

The reservoir is in the front of the left fender well. Removing the front half of the fender liner will give you access. The wires for the sensor hang below and can get corroded or clipped.
Forum: Audi 4000 / Coupe GT Discussion
04-25-2014, 06:01 PM
Replies: 38
Views: 3,500
Posted By squidix9

While you are thinking about it decide which hubs...

While you are thinking about it decide which hubs and axles you plan on using. The 4kq will be 4x108 hubs and the 5ktq will be 5x112
Forum: Audi 4000 / Coupe GT Discussion
04-25-2014, 05:55 PM
Replies: 38
Views: 3,500
Posted By squidix9

Indeed the 5k is wider, but similar. The 4k will...

Indeed the 5k is wider, but similar. The 4k will have the geometry you want . However the CGT since it is not Quattro will have a completely different setup. You be either making your own perches or...
Forum: A6 / S6 (C6 Platform) Discussion
04-25-2014, 05:46 PM
Replies: 2
Views: 1,192
Posted By squidix9

There are sensors on the lower control arms. If...

There are sensors on the lower control arms. If one is funky VagCom should pinpoint it.
Forum: Audi allroad
04-24-2014, 08:16 PM
Replies: 14
Views: 16,090
Posted By squidix9

There are a slew of places it can leak. You've...

There are a slew of places it can leak. You've hit the valve cover gaskets and next the cam seals. With an nspection mirror check the chain tensioner seals. If they aren't leaking, don't replace...
Forum: Audi allroad
04-24-2014, 08:08 PM
Replies: 14
Views: 16,090
Posted By squidix9

You don't need to pry the can seals out. You'll...

You don't need to pry the can seals out. You'll struggle trying to get to them. You'll mangle the seals and may damage the surface if not lucky. Trying to get the new seals in will be more than a...
Forum: Audi 90 / 80 / Coupe quattro / Cabriolet
04-24-2014, 08:11 AM
Replies: 2
Views: 780
Posted By squidix9

I'm guessing you are not in the states if you...

I'm guessing you are not in the states if you have a CQ with a 2.8 and also being a '93?
Forum: Audi A3 / S3 / RS 3
04-17-2014, 02:18 PM
Replies: 8
Views: 1,355
Posted By squidix9

Lot's of room in the back.

Lot's of room in the back.
Forum: Audi A3 / S3 / RS 3
04-17-2014, 02:13 PM
Replies: 8
Views: 1,355
Posted By squidix9

Notice the camera under the number plate.

Notice the camera under the number plate.
Forum: Audi A3 / S3 / RS 3
04-17-2014, 02:08 PM
Replies: 8
Views: 1,355
Posted By squidix9

Gorgeous interior

Gorgeous interior
Forum: Audi A3 / S3 / RS 3
04-17-2014, 01:55 PM
Replies: 1
Views: 990
Posted By squidix9

The story. ...

The story.


http://www.wcoty.com/web/media_release.asp?release=96&year=2014
Forum: Audi A3 / S3 / RS 3
04-17-2014, 07:57 AM
Replies: 1
Views: 990
Posted By squidix9

Audi wins World Car of the year with the A3

Scott Keogh with the award at the Audi display NYIAS.
Forum: A6 / S6 (C6 Platform) Discussion
04-15-2014, 03:53 PM
Replies: 3
Views: 2,005
Posted By squidix9

Most pads now have a bonded pad on the back of...

Most pads now have a bonded pad on the back of the actual backing plate. No more shims.
Showing results 1 to 25 of 496
 
Page 1 of 20
1
2
3
11
Last »


 
Forum Jump


All times are GMT -8. The time now is 10:33 AM.