Q7 POS please help
#22
Audiworld Junior Member
Thread Starter
Join Date: Jun 2014
Posts: 78
Likes: 0
Received 0 Likes
on
0 Posts
i have had to work alot lately, i have been driving it after clearing DTCs, filled up with gas after driving for several days and the MIL came one again a few minutes after getting back underway, have not scanned it. I will do it tomorrow and post results
#23
Audiworld Junior Member
Thread Starter
Join Date: Jun 2014
Posts: 78
Likes: 0
Received 0 Likes
on
0 Posts
been on vacation. gonna order the oxygen sensor after this reply, the MIL keeps coming on after filling up with gas. So this irritation must end. Hoping it would just go away. I have replaced o2 sensors before and have the special socket, i imagine its a pain and have seen a special tool at ecs automotive, hope i dont need it. I will holler back when im done, i think i will order that v300 switch also, thanks for the help jake
#25
Audiworld Junior Member
Thread Starter
Join Date: Jun 2014
Posts: 78
Likes: 0
Received 0 Likes
on
0 Posts
WELL, i spent all fricking day on that POS and reset all DTCs, cleared the MIL, started it up with no MIL, then before shifting into drive, the MIL came back on, am I doing something wrong, did i just waste my day and money on a new O2 sensor, you were saying it was a wiring issue, WTF
#29
AudiWorld Super User
No fuse.
Are you still getting the 008753 ?
You're going to have to trace that wire all the way back unfortunately.
Continuity and/or tone tests will help find the issue
Are you still getting the 008753 ?
008753 - Oxygen (Lambda) Sensor B1 S1
P2231 - 004 - Signal Shorted to Heater Circuit - Intermittent - MIL ON
P2231 - 004 - Signal Shorted to Heater Circuit - Intermittent - MIL ON
Continuity and/or tone tests will help find the issue
Last edited by jakematic; 08-01-2014 at 07:06 PM.