mike5

So I'm trying to get the windows to roll up/down with the remote. I went to module 46 I think (Central Conv) and observed the value of 11788. I erased it and typed 11852 and hit recode. I can go back there now and observe that this new value is there. BTW: I did not see a "test" button or anything. Having done this, I still can't roll the windows up or down with the remote. What am I doing wrong or not doing? Do I need to start the car after recoding and drive it and then try again?

Thanks,
mike

mike5

I believe I'm supposed to see 95 in Adaptation #62, but nothing shows up. Should I just update it with 95?

Darryl@HPAMotorsport

...it may be an indication that the ECU in question will not display the information. I have seen a few examples of this recently, where the ECU shows no value no matter what channel is accessed.

Nevertheless, I believe Mike5 has resolved this with a VAD software update.

mike5

With a little time we'll figure out exactly what is going on!

Darryl@HPAMotorsport

How's that software working so far?

mike5

I did the VAD on a sedan from previous and I can read block 62 and others using both versions of the software. So I don't know if something weird was going on with my Palm or what (all I can point to). I will repeat this on the Avant as well to find out what happens.

Thanks,
Mike

drOopy01

Darrryl,

I'm having this problem also! This is Rory by the way with the 2003 A4 1.8TQ. I recoded it to 11884 and was able to get the autolock function to work but the windows won't go up with remote when i press the lock/unlock button. Could this be because i haven't done adaption 62 with a code of 95?

Darryl@HPAMotorsport

Rory,

Please sned me an e-mail to darryl@vadpro.com with the applicable ECU P/N and I will check the procedure. The previous example was solved with a software update. As your version is up to date, I will look at other reasons. Thanks.

drOopy01

Thanks darryl will do over the weekend.

Thanks!