OK my new Milltek exhaust goes on this weekend. Any suggestions before I start? The car will be...
#3
AudiWorld Senior Member
Thread Starter
Join Date: Nov 2001
Posts: 1,314
Likes: 0
Received 0 Likes
on
0 Posts
Yup. 90mm sale item from Strat. Bought it online while I was at TT-West! Got it the following...
Friday but I was at Ferg's driving school that weekend so had to wait until this weekend to install. I'll take some pics and post. Heard there was a trick to make sure the tips align correctly?
#4
I did read something abot that recently:
loosen the clamps and rotate until the tips
align- something like that.
Anxious to hear what you think, I've been thinking
about this... Is this resonated/non-resonated?
scot
align- something like that.
Anxious to hear what you think, I've been thinking
about this... Is this resonated/non-resonated?
scot
#5
A few tips....
make sure you have some good clamps... get some exhaust compound goop to seal up the connections (prone to leaking)... if you have access to an impact wrench, that helps a lot with clamp tightening... as Scot said, rotation of the center pipe changes alignment of the rear can...
Thats about all I can think of right now.
Thats about all I can think of right now.