XCLR8TT

I've had my TTDA for a about 2.5 years but never completed the feeds. I've always had one out to the grille but the other was in the wheel well. I had some time the past 2 weekends since and decided to route them out.

One still routes through the wheel well, but I cut out a piece of the fender bracket to allow it to be routed out to the front.
<img src="http://images20.fotki.com/v355/photos/4/419847/4268117/DSCN2514-vi.jpg">

The bracket is cut out for the tube on the right. I unbolted the fender and pulled it out to gain easier access with the Dremel tool.



<img src="http://images20.fotki.com/v356/photos/4/419847/4268117/DSCN2515-vi.jpg">

Both tubes are now out to the front...

<img src="http://images19.fotki.com/v359/photos/4/419847/4268117/DSCN2516-vi.jpg">

While I was there I did the Alien delete mod and with further creative use of Zipties to attach the aluminum brackets to the back side of the bumper.

<img src="http://images19.fotki.com/v358/photos/4/419847/4268117/DSCN2517-vi.jpg">
<img src="http://images20.fotki.com/v356/photos/4/419847/4268117/DSCN0001-vi.jpg">

tiTTS

I plan on putting the flanges through the black screen piece in the bumper, which you put the feeds behind. Do you see any problems with doing so, other than maybe havng to trim the flanges on top and bottom to fit?

TIA

XCLR8TT

at least that will keep the big chunks out of the intake.

TTapsale

Where did you get those "feeds" showing through the grill?
Are they what your what you zip tied?...to the grill? TIA

trnc

prone to hydrolock??

MOBlueTT

Excellent ! ! ! and hydrolock ONLY occurs when you drive through a river, stream or lake ;-P

ITALSKIER

nice job..........good write up.....

InTTruder

Nice: the nozzles 'finish' the job.

XCLR8TT

zip tie them to the back side of the bumper behind the grille..

migo1980

Notice any improvement?