You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, join AudiWorld.com today!
NEW FEATURE at AudiWorld!!! We now have a fully integrated Wiki!!
Check it out!
For full post editing rights, please reply to this thread. Thanks!
For tips on using the forums please visit the following page: Forum Tips Be sure to check out Threaded View!!!
facebook users, please become a fan of AudiWorld's page
We've gotten complaints about spam/virus Private Messages. Any such messages are completely bogus, and should be ignored completely. Read more here.
I have a set of Audi R8 headlights that I would like to put on my A6. They are just barely too small leaving a slight gap between the bumper and where the turn signal sits. I don't want them to bounce around as I am driving therefore would like to know what the best material is that I should use to fill in the gap and mount them so that they fit snug?