Loose bolt on subframe need solution.
06-01-2009, 05:17 PM
#1
AudiWorld Member
Thread Starter
Join Date: Mar 2009
Location: Chicago
Posts: 238
Likes: 0
Received 0 Likes
on
0 Posts
Loose bolt on subframe need solution.
Hello again to all members. When installing the lower, rear (bent) control on the front passenger side of my car I noticed that one of the three bolts on the subframe was loose. The bolt is one of the smaller bolts and is closer to the rear end of the vehicle. When I try to tighten the bolt (or loosen) it just spins around and doesn't go in or out. The other smaller bolt and the larger bolt (closer to the arm itself) is solid and I was able to tighten both of them properly. How much of a risk is it to the car and my safety to just neglect it? What are ways to fix it? Should I pry it out and tap new threads since it seems like the threads are worn out? Thanks for all the help in advance.
06-07-2009, 09:43 AM
#3
AudiWorld Super User
Join Date: Sep 2003
Posts: 3,931
Likes: 0
Received 0 Likes
on
0 Posts
Mine was also like you described. I think that is where the aftermarket subframe stiffener would hook in. I didnt put an insert in when I installed the bar and havent had a problem. Tim @ NEA said it would be fine as long as grade 8 bolts were properly torqued. Has lack of this bolt caused any problems for anyone?
Rod
Rod
Thread
Thread Starter
Forum
Replies
Last Post
RDP595
Audi 100 / A6 (C4 Platform)
2
01-01-2007 03:45 PM
RyanB5S4
S4 / RS4 (B5 Platform) Discussion
1
11-02-2006 05:45 PM
MikeB490
Audi 90 / 80 / Coupe quattro / Cabriolet
4
08-26-2003 09:30 AM
