Rev limiter on modified B5 Engine for Garretts
#1
Rev limiter on modified B5 Engine for Garretts
Hi guys,
Fairly new to this forum although I have browsed it a lot and found some fantastic information here over the years!
I am from across the pond and currently building by B5 RS4 engine with garretts, I went for the GT2871R-2's.
The engine is a B5 RS4 with wossner lower compression pistons, Pauter S4 rods, 2.4 head ported and polished, stock valves, 034 springs and retainers, stock cams and stock lifters.
I am trying to work out what RPM I can raise the limiter to since these turbo's as some of you will know are a little late in the spooling, I am getting full spool around 6k at the moment although it has not been mapped yet but not going to be able to pull that back much.
Has anyone on here got a similar setup?
Cheers guys,
Rich.
Fairly new to this forum although I have browsed it a lot and found some fantastic information here over the years!
I am from across the pond and currently building by B5 RS4 engine with garretts, I went for the GT2871R-2's.
The engine is a B5 RS4 with wossner lower compression pistons, Pauter S4 rods, 2.4 head ported and polished, stock valves, 034 springs and retainers, stock cams and stock lifters.
I am trying to work out what RPM I can raise the limiter to since these turbo's as some of you will know are a little late in the spooling, I am getting full spool around 6k at the moment although it has not been mapped yet but not going to be able to pull that back much.
Has anyone on here got a similar setup?
Cheers guys,
Rich.
Thread
Thread Starter
Forum
Replies
Last Post
2001B5Rs4
S4 / RS4 (B5 Platform) Discussion
0
04-05-2018 11:22 AM
danyman80
S4 / RS4 (B5 Platform) Discussion
0
11-17-2013 06:01 AM
ckymike
S4 / RS4 (B5 Platform) Discussion
5
01-13-2007 08:23 AM
Reggie3
S4 (B6 & B7 Platforms) Discussion
12
12-14-2003 08:49 PM