Noob Question Inside....
#1
Noob Question Inside....
I recently aquired a set of tires and wheels from a fellow Audiworld memeber who was running them on his car.
My question is, other then checking air pressure, is there anything I need to do prior to or immediately after mounting them? Or is it mount, tighten to specs (which btw are?), and drive.
Thanks in advance...
Tyler
My question is, other then checking air pressure, is there anything I need to do prior to or immediately after mounting them? Or is it mount, tighten to specs (which btw are?), and drive.
Thanks in advance...
Tyler
#2
AudiWorld Expert
First - be sure you have the correct wheel bolts. - You just can't interchange them
because the length and seating can vary.
You need to torque the bolts - and the settings can vary. I think my 95 Audi 90 is 80lbs and my A4 is 89 ft-lbs.
I use antisieze on my threads - to prevent them from rusting on. But there are people who say it is not correct to do so.
You need to torque the bolts - and the settings can vary. I think my 95 Audi 90 is 80lbs and my A4 is 89 ft-lbs.
I use antisieze on my threads - to prevent them from rusting on. But there are people who say it is not correct to do so.
Thread
Thread Starter
Forum
Replies
Last Post
OneGuyInCA
A6 / S6 (C5 Platform) Discussion
32
04-18-2008 11:12 AM
Steve Trac, Sec 303
S4 / RS4 (B5 Platform) Discussion
2
12-29-2002 10:57 AM
Luke's S4
S4 / RS4 (B5 Platform) Discussion
6
05-07-2001 08:14 PM