Engine Dyno Plot of 1.8L bored to 1.9L on 24.5 PSI Boost.
#1
AudiWorld Senior Member
Thread Starter
Join Date: Mar 2000
Posts: 1,173
Likes: 0
Received 0 Likes
on
0 Posts
Engine Dyno Plot of 1.8L bored to 1.9L on 24.5 PSI Boost.
<center><img src="http://pictureposter.audiworld.com/1185/18t35.jpg"></center><p>Audisport cams, GT35R plus other mods.
This setup was designed to run on a every day street car.
More power is possible going to higher boost with suitable higher octane Fuel.
This setup was designed to run on a every day street car.
More power is possible going to higher boost with suitable higher octane Fuel.
#7
AudiWorld Senior Member
Thread Starter
Join Date: Mar 2000
Posts: 1,173
Likes: 0
Received 0 Likes
on
0 Posts
Re: Torque line is impressive, shows a lot is left. Nice job, where does meth. inj. start -4500?
starts at 21 psi.
Water injection is setup and run by boost level from the cooling mist controller.
Water injection is setup and run by boost level from the cooling mist controller.
Trending Topics
#8
Re: Engine Dyno Plot of 1.8L bored to 1.9L on 24.5 PSI Boost.
Hey Lucas. Does your engine have a standard 1.8t block thats bored out? I didn't know that boring to a 1.9 would make a bigger difference in spool for a turbo that large. Thanks for the info.
#10
AudiWorld Senior Member
Thread Starter
Join Date: Mar 2000
Posts: 1,173
Likes: 0
Received 0 Likes
on
0 Posts
Re: Engine Dyno Plot of 1.8L bored to 1.9L on 24.5 PSI Boost.
Its not my engine, its a engine we have finnished for a customer.
Its a Standard 1.8 block bored out to 83.5mm
The Gt35R also has a 0.63ar exhaust.
However the Cams we used seem to work really well.
Its a Standard 1.8 block bored out to 83.5mm
The Gt35R also has a 0.63ar exhaust.
However the Cams we used seem to work really well.