Audi A6 2006 - computer connection without the ignition
#1
Audi A6 2006 - computer connection without the ignition
Hello Friends
two days ago i was faced with the common audi a6 issue
when i put the key in the egnition socket the sterring wheel wont lock or unlock (the steering wheel is always unlocked now) and the system wont go up wich means i cant turn on the engine.
I tried disconecting the steering column module and connecting it back again . Since then when i put the key in the monitor says "An Installed Component is not valid. Please contact Audi Workshop" and nothing works, i cant turn on the egnition.
does anybody knows how can i connect my obd or diagnostic scanner (computer) without activating the switch and turning the egnition on .
the battery is in good condition and i already tried pressing the brake , turning on the high light on and turning on the hazard button simultaneously.
nothing works , please help
two days ago i was faced with the common audi a6 issue
when i put the key in the egnition socket the sterring wheel wont lock or unlock (the steering wheel is always unlocked now) and the system wont go up wich means i cant turn on the engine.
I tried disconecting the steering column module and connecting it back again . Since then when i put the key in the monitor says "An Installed Component is not valid. Please contact Audi Workshop" and nothing works, i cant turn on the egnition.
does anybody knows how can i connect my obd or diagnostic scanner (computer) without activating the switch and turning the egnition on .
the battery is in good condition and i already tried pressing the brake , turning on the high light on and turning on the hazard button simultaneously.
nothing works , please help
The following users liked this post:
David hanuka (04-17-2021)
Thread
Thread Starter
Forum
Replies
Last Post
Audi786
A6 / S6 (C6 Platform) Discussion
18
03-10-2024 07:10 PM
Glenn Morrow
A6 / S6 (C6 Platform) Discussion
0
09-22-2019 06:55 PM
tastrike
A6 / S6 (C6 Platform) Discussion
0
05-09-2016 04:02 PM