rear door curtians
02-04-2014, 08:51 PM
#2
AudiWorld Super User
See parts diagram here: http://www.audiusaparts.com/parts/20...iagram=1362855
Remove trim molding pieces
Remove 3 bolts
Release 2 part clip near entry lamp - part #3
Release 8 door clips
Release control cable and electrical connections
Remove door trim panel - #1
Turn push rod (#29) 90 degrees about axis and detach from blind (#26)
Turn push rod 90 degrees to detach from motor
Remove 3 bolts along bottom of blind assembly
The procedure pages in the erWin manual are quite lengthy and my guesstimate would be at least 2 hours to disassemble.
I would absolutely have extra door panel clips on hand before you start, a T10383, and a good set of trim tools.
Remove trim molding pieces
Remove 3 bolts
Release 2 part clip near entry lamp - part #3
Release 8 door clips
Release control cable and electrical connections
Remove door trim panel - #1
Turn push rod (#29) 90 degrees about axis and detach from blind (#26)
Turn push rod 90 degrees to detach from motor
Remove 3 bolts along bottom of blind assembly
The procedure pages in the erWin manual are quite lengthy and my guesstimate would be at least 2 hours to disassemble.
I would absolutely have extra door panel clips on hand before you start, a T10383, and a good set of trim tools.
Last edited by jakematic; 02-04-2014 at 10:24 PM. Reason: erWin link corrected to NAR
Thread
Thread Starter
Forum
Replies
Last Post
bittersweetno1
Audi 90 / 80 / Coupe quattro / Cabriolet
2
07-17-2003 04:23 PM
machoquattro
Audi 90 / 80 / Coupe quattro / Cabriolet
1
03-24-2002 06:03 AM
