You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, join AudiWorld.com today!
Notices
NEW FEATURE at AudiWorld!!! We now have a fully integrated Wiki!!
Check it out!
For full post editing rights, please reply to this thread. Thanks!
For tips on using the forums please visit the following page: Forum Tips Be sure to check out Threaded View!!!
facebook users, please become a fan of AudiWorld's page
We've gotten complaints about spam/virus Private Messages. Any such messages are completely bogus, and should be ignored completely. Read more here.
Getting my 88' 80Q back on the road after a 4 year hibernation. When I was replacing my fuel hardlines I noticed the center bearing was sagging. No surprise for a 310,000 mile car. So I want to rebuild the shaft (rather than Audi give me "the shaft" for a new one). I was able to locate the end bearings (no boots) from GKN/Loebro, and the middle support bearing from 034 motorsport. I just need the middle joint and the boots for the end bearings. Now I called Blau and they no longer have the rebuild kits for the 80Q. But they did list end bearings for models from 84-02 or something like that. It seemed like they covered every model except the 80/90 series. Does the B3 share propshaft components with any other model. I most surely thought that the early 80 models might share the same drivetrain as the 4000. Any help is appreciated. Thanks gang!
04-21-2012, 04:43 PM
Propshaft rebuild
Threaded Mode