Lucas Auto Transmission Slip fix? Does it work?
#1
Lucas Auto Transmission Slip fix? Does it work?
Im planning on doing this to my car because it slips when I press on the gas pedal. Does anyone here used it? Would it be worth trying?
Tranny shifts fine it is just slipping like a totally worn clutch...
Please help
Tranny shifts fine it is just slipping like a totally worn clutch...
Please help
#3
OK
So I did it. I removed exact amount of the fluid from the tranny and then added the Lucas. Then I went for a ride and there was no difference. This product swells the rubber o-rings/gaskets so my assumption is that in some time the pressure should go up and affect positively the shifting as well as the power transfer. After 4 hours I went for a ride again and could already feel better shifting. I think that this thing might work for worn out trannies that are ~200,000 miles. Time will show result of that operation.
In near time I will write more about that thing. If something goes wrong I have nothing to lose. I just hope its not going to overheat...
Wish me luck
So I did it. I removed exact amount of the fluid from the tranny and then added the Lucas. Then I went for a ride and there was no difference. This product swells the rubber o-rings/gaskets so my assumption is that in some time the pressure should go up and affect positively the shifting as well as the power transfer. After 4 hours I went for a ride again and could already feel better shifting. I think that this thing might work for worn out trannies that are ~200,000 miles. Time will show result of that operation.
In near time I will write more about that thing. If something goes wrong I have nothing to lose. I just hope its not going to overheat...
Wish me luck
Thread
Thread Starter
Forum
Replies
Last Post
Audi Other FS: 2007 Audi RS4 black/black CCW
ilikeit
Vehicles For Sale - Archive (NO NEW POSTS HERE)
2
01-09-2016 09:24 AM
stormchaser1967
Audi A5 / S5 / RS5 Coupe & Cabrio (B8)
0
09-02-2015 09:26 AM
stormchaser1967
New Member Welcome Area
0
09-01-2015 01:29 PM