Second round of Logging. Numbers look much happier now.

[k04/rs6north]

If you running KO4 software, as the earlier post would indicate, you are probably not the first, but there are not too many running a walbro, KO4s and AWE KO4 software / MAF - as such, you are going to have to do most of the hard lifting yourself.

That said, I would say that you will have to wait until you have a boost guage until you start tweaking. When you have a boost guage:
1) set all lemmi setting to zero and then get your mbc set to 21 psi
2) after #1 is done, do wot 3rd gear runs and adjust primary only (.875 at wot)
3) doing 1 & 2 will allow you to re-set your fueling for your walbro
4) once you have done this, if your would like to go for higher boost, adjust the mbc and find the psi you desire
5) once 4 is done, my guess is that very small changes will be required, maybe +1 / +3 % primary and maybe -1 / -3 timing (these are guesses only but educated as I am running higher psi on my k16 hybrids on AWE KO4 software on a AWE MAF