Love it or leave it, here it is...
#1
AudiWorld Senior Member
Thread Starter
Join Date: Jan 2002
Posts: 1,038
Likes: 0
Received 0 Likes
on
0 Posts
Love it or leave it, here it is...
It's not quite done yet, a few touches more (maybe black out the alumin on the shifter, red on the center of the wheel hub...). The red looks brighter because of the sun/flash... oh well... it just screams red... Maybe I'll do something else with the wheel, the rest is good.
<img src="http://pictureposter.audiworld.com/30766/rs4_e-4.jpg">
<img src="http://pictureposter.audiworld.com/30766/rs4_e-2.jpg">
<img src="http://pictureposter.audiworld.com/30766/rs4_e-3.jpg">
<img src="http://pictureposter.audiworld.com/30766/rs4_e-4.jpg">
<img src="http://pictureposter.audiworld.com/30766/rs4_e-2.jpg">
<img src="http://pictureposter.audiworld.com/30766/rs4_e-3.jpg">
#3
AudiWorld Senior Member
Thread Starter
Join Date: Jan 2002
Posts: 1,038
Likes: 0
Received 0 Likes
on
0 Posts
A word or two about dyno stuff...
This car is the only car in the states running Revo software... they custom mapped it for the engine and full Miltek exhaust. It only happened because Revo was here working on the X-51 Cayman GTR project. It did go on the dyno before and after the software install. I've been told that I need to drive the car so that it "learns" and adapts, then they'll dyno it again. These cars apparently don't like the dyno, so the numbers are almost never flattering.
They didn't want me to post the #'s until I've driven it and it's adjusted. I have them out in the car, and may post them later anyway... but I've got to make the kids dinner.
They didn't want me to post the #'s until I've driven it and it's adjusted. I have them out in the car, and may post them later anyway... but I've got to make the kids dinner.
#4
red piping on the seats would really set it off i think. it would bring the whole interior together
it looks rather disjointed they way it is now IMO. good i idea though. the steering wheel may be a little much too