Search: Posts Made By: PorpShow
Showing results 1 to 25 of 77
Search took 0.37 seconds.
05-08-2006, 02:21 PM
Replies: 1
Views: 879
Posted By PorpShow

knocking in steering rack

I've started hearing knocking sounds in my suspension. The outer tie rods were loose, so I replaced them. Still hearing occasional clunking, so I replaced the inner tie rods today. The clunking is...
03-15-2006, 08:26 AM
Replies: 6
Views: 415
Posted By PorpShow

it's right behind/under the drivers headlight

there's a little line between the headlight washer pump and your headlight squirters. Easy to miss when pulling the bumper
02-26-2006, 09:27 PM
Replies: 7
Views: 2,268
Posted By PorpShow

i'm running that with 6mm spacers in rear

to clear the control arms. Rear rubs on big bumps or really hard cornering, but perfectly streetable (I have eibach springs + bilstiens)
You can stagger AWD just fine if you match rolling diameter. ...
02-26-2006, 02:12 PM
Replies: 6
Views: 1,405
Posted By PorpShow

buy an S4...

buy an S4...
02-26-2006, 01:06 PM
Replies: 11
Views: 237
Posted By PorpShow

RS4 and Mustang? driving like idiots in Russia

Repost?<ul><li><a href="http://www.metacafe.com/watch/42142/russian_style_driving/">http://www.metacafe.com/watch/42142/russian_style_driving/</a</li></ul>
02-24-2006, 12:29 PM
Replies: 22
Views: 376
Posted By PorpShow

It's a "MIG" from top gun

<center><img src="http://www.salsburg.com/California/Miramar/TopGunMig.jpeg"></center><p>except it's not painted black with the red star.
02-22-2006, 09:56 AM
Replies: 17
Views: 305
Posted By PorpShow

We made some custom DP's/exhaust for my car last week

But we have a lift, bandsaw, grinders, MIG, TIG, etc.
Not easy, but doable.
Took about 6-8 hours labor for just the DP/exhaust fab. Add in your engine removal/replacement time. A lot of...
02-17-2006, 07:38 AM
Replies: 18
Views: 292
Posted By PorpShow

or into the Timing belt cover right below the...

or into the Timing belt cover right below the TBB...ask me how I know...
02-13-2006, 09:59 AM
Replies: 43
Views: 524
Posted By PorpShow

Hourly rate for a capable programmer $100+/hr, so...

Hourly rate for a capable programmer $100+/hr, so for 2.5 hrs work, not worth it.
01-25-2006, 03:05 PM
Replies: 6
Views: 361
Posted By PorpShow

HPC is the best place around here (Utah)

<ul><li><a href="http://www.hpcoatings.com/hipercoat.htm">...linky...</a></li></ul>
01-20-2006, 10:10 AM
Replies: 3
Views: 125
Posted By PorpShow

Engine is out...time for upgrades!

My t-belt failed recently...<a href="https://forums.audiworld.com/s4/msgs/2219196.phtml">thread</a>
turns out it was a cam cap bolt that had fallen down next to the belt unnoticed. At least I...
01-19-2006, 08:14 AM
Replies: 46
Views: 897
Posted By PorpShow

My office has an unofficial fast/nice cars row...we all show the proper care...

my only goal it to have the fastest car at work...then i'll be happy!
The competition:
BMW Z3 - meh (not sure why he parks there)
SRT4 - cheap but fast
evo8 - once he's out of warrantee, watch...
01-04-2006, 02:08 PM
Replies: 9
Views: 313
Posted By PorpShow

timing belt failure after 2000 miles :(

so, i've driven less than 2000 miles since a complete timing belt/pulleys/pumps replacement. On the way to work, engine died. Crank it over a bit...sounds like no compression !@#$...pop the hood...
01-04-2006, 09:03 AM
Replies: 8
Views: 351
Posted By PorpShow

VW's do it all the time... :)

seriously, if you're just idling, you'll be fine pulling the car out. You know how long it takes to open the t-stat just idling? There isn't that much heat, and an alum block/head is a great heat...
12-13-2005, 07:31 PM
Replies: 23
Views: 591
Posted By PorpShow

Boiling temp also raises with pressure...

so as coolant starts to boil, system is pressurized and raises boiling temp. A pressurized system can absorb much more heat than an open system.
11-25-2005, 07:06 PM
Replies: 10
Views: 355
Posted By PorpShow

might not be the wheels...

especially with the mention of your CV boot issue. Could it be the cv joint or axle is giving you the shimmy? I'm replacing my bad CV tomorrow, and i'm pretty sure it's causing my high speed...
11-02-2005, 11:09 AM
Replies: 5
Views: 1,026
Posted By PorpShow

Port Status: OK - Interface Not Found - Solid...

Port Status: OK - Interface Not Found - Solid red LED
11-01-2005, 04:48 PM
10-31-2005, 11:40 AM
Replies: 5
Views: 1,026
Posted By PorpShow

will symphony radio in safe mode ground the k-line?

I have &lt;9v on k line and continuity between pin1 and ECU and plug and ground. But i still get the "interface not found" error. Next step to get VAG to connect?
10-27-2005, 07:27 AM
Replies: 30
Views: 423
Posted By PorpShow

how much? I'm in slc and about ready for one myself.

We buy all our stuff from Dr Gas.
Can we meet up so I can hear it sometime?
10-27-2005, 07:20 AM
Replies: 26
Views: 527
Posted By PorpShow

The cops extra notation makes the ticket inadmissable

If you take it to court, the ticket becomes inadmissable evidence because of the extra irrelevant and biased information. It should then be dissmissed. Any lawyers out there to back me up on this...
10-12-2005, 02:36 PM
Replies: 12
Views: 306
Posted By PorpShow

does it go WOOO WOOO!?

does it go WOOO WOOO!?
09-16-2005, 12:43 PM
Replies: 6
Views: 155
Posted By PorpShow

anyone else see this? seems like a sweet deal

Anyone bought from this place before? They have good ebay feedback, but it would be nice to hear from someone here who bought a bumper from this guy.<ul><li><a...
09-14-2005, 02:05 PM
Replies: 5
Views: 168
Posted By PorpShow

I bet his tires wear unevenly...

there appears to be an S4 parked next to the road, if someone complains about Audi content. (I'd like to see him do that in the S4!)<ul><li><a...
09-13-2005, 12:30 PM
Replies: 4
Views: 183
Posted By PorpShow

mp3car.com if you are reasonably computer savvy

you could pay through the nose for Drivesoft. Or do it yourself.

I'm working on a Windows Media Center PC setup for my Eurovan.

Besides the cost of the PC itself (which is prety much up to...
Showing results 1 to 25 of 77
 


 
Forum Jump


All times are GMT -8. The time now is 07:36 PM.