AudiWorld Forums

 
Page 1 of 20
1
2
3
11
Last »
Search: Posts Made By: QCRAZY
Showing results 1 to 25 of 499
Search took 1.16 seconds.
Forum: Q5/SQ5 MKI (8R) Discussion
03-30-2010, 04:44 PM
Replies: 44
Views: 35,760
Posted By QCRAZY

Did you ever figure out the ESP warning???

Did you ever figure out the ESP warning???
Forum: Audi allroad
04-24-2009, 04:28 PM
Replies: 8
Views: 1,128
Posted By QCRAZY

Drive down to my house (Cedar Rapids) and I'll...

Drive down to my house (Cedar Rapids) and I'll change it.
Forum: S4 / RS4 (B5 Platform) Discussion
03-28-2009, 06:12 PM
Replies: 13
Views: 1,454
Posted By QCRAZY

Lame....upgraded control arms that connect to the...

Lame....upgraded control arms that connect to the wheel through a squishy bushing. Set-up is only as good as it's weakest link. ;)
Forum: S4 / RS4 (B5 Platform) Discussion
03-28-2009, 01:24 PM
Replies: 13
Views: 1,454
Posted By QCRAZY

Someone needs to make solid monoballs for the...

Someone needs to make solid monoballs for the rear wheel bearing housing; lower bushing. The factory set-up is a joke.
Forum: Audi allroad
03-18-2009, 05:54 PM
Replies: 24
Views: 1,991
Posted By QCRAZY

Loctite only works in the absence of oxygen. If...

Loctite only works in the absence of oxygen. If you don't get it tight, it may still have oxygen and won't set anyway.

If you want to use it, make sure you use the "blue", non-permanent type.
Forum: Audi allroad
03-18-2009, 05:26 PM
Replies: 3
Views: 2,880
Posted By QCRAZY

It's likely dealer...

It's likely dealer only......http://genuineaudiparts.com/ has it pretty cheap.

Parts like that is why my air suspension is going bye bye this Summer. I lost all four air bags and the compressor...
Forum: Audi allroad
03-15-2009, 05:41 PM
Replies: 24
Views: 1,991
Posted By QCRAZY

Yup

Yup
Forum: Audi allroad
03-15-2009, 03:17 PM
Replies: 24
Views: 1,991
Posted By QCRAZY

Re: Not giving up your secret method of finding part numbers?

Same way everyone gets them...ETKA
Forum: Audi allroad
03-15-2009, 09:48 AM
Replies: 8
Views: 524
Posted By QCRAZY

Straight from the source.....

<ul><li><a href="http://www.audi.ddsltd.com/">Click!</a></li></ul>
Forum: Audi allroad
03-15-2009, 09:45 AM
Replies: 24
Views: 1,991
Posted By QCRAZY

Not sure on torque....

...it's a hollow "bolt" that seals when the washers crush. Too tight may ruin the bolt. You need to tigthen it enough to get the copper crush, nothing more. That should be put right around what...
Forum: Audi allroad
03-15-2009, 09:38 AM
Replies: 14
Views: 867
Posted By QCRAZY

CV joints and crankcase suction pump (if equipped)

CV joints and crankcase suction pump (if equipped)
Forum: Audi allroad
03-15-2009, 06:06 AM
Replies: 24
Views: 1,991
Posted By QCRAZY

That's going to be a....

....biatch to get at.

Bolt p/n: N 901 836 03
Washer p/n: N 013 807 6 (need two)

That is the pressure line that feeds your N75 valve, and ultimately back to your wastegates.
Forum: Audi allroad
03-15-2009, 05:55 AM
Replies: 14
Views: 867
Posted By QCRAZY

Re: ..probably closer to a squeal

Have you checked the PS fluid level? Sounds like you may be a touch low.

Make sure you follow the directions in the manual on checking your PS fluid.
Forum: Audi allroad
03-15-2009, 05:54 AM
Replies: 14
Views: 867
Posted By QCRAZY

**BLUSHES**

**BLUSHES**
Forum: Audi allroad
03-14-2009, 02:26 PM
Replies: 14
Views: 867
Posted By QCRAZY

"That" noise?

"That" noise?
Forum: Audi allroad
03-13-2009, 07:21 PM
Replies: 7
Views: 862
Posted By QCRAZY

Re: Burning smell and thump

Smell is likely the transmission rear output seal leaking. Common problem, leaks on the cats and stinks.

The thump is probably your 135k mile tranny fluid sucking the remaining life out of your...
Forum: Audi allroad
03-13-2009, 05:01 PM
Replies: 7
Views: 449
Posted By QCRAZY

Yeah.....that wasn't on purpose. I didn't know search was down.

I bought my parts from McMaster.
Forum: Audi allroad
03-13-2009, 04:54 PM
Replies: 5
Views: 388
Posted By QCRAZY

Where's the lever and the fulcrum??

By the definition of offset, the geometery of the wheels have to "match". As long as the spacers are hubcentric there is no lever; at least no different then what the factory wheel would have.

In...
Forum: Audi allroad
03-12-2009, 05:08 PM
Replies: 5
Views: 388
Posted By QCRAZY

Re: you would need a 20MM spacer and new lug bolts...

Spacer width doesn't matter. Any spacer should be hubcentric. Once bolted it will have similar geometery/forces as the factory wheel.
Forum: Audi allroad
03-12-2009, 05:02 PM
Replies: 7
Views: 449
Posted By QCRAZY

Search would help you.....

On some cars they are seized; more so in Northern climates. Usually the hose portion will come out but the tees can seize.

If you get the hose out, call Arnott and tell them to send you a spare...
Forum: S4 / RS4 (B5 Platform) Discussion
03-09-2009, 05:24 PM
Replies: 5
Views: 1,673
Posted By QCRAZY

Sounds like a rock stuck in the brake....

Sounds like a rock stuck in the brake....
Forum: Audi allroad
03-05-2009, 06:12 PM
Replies: 16
Views: 807
Posted By QCRAZY

They knock when they go bad.....

....

The tech in the story above likely overtightened the adjuster when he changed the seal and damaged the adjuster itself. The manual specifically warns against overtightening. Your car may...
Forum: S4 / RS4 (B5 Platform) Discussion
03-03-2009, 05:13 PM
Replies: 9
Views: 1,016
Posted By QCRAZY

Re: thanks.. i've checked that one too.. it's not directly under the battery right?

Sounds right....the one the battery ground cable leads too.

There should be no wires under there to be pinched. You either have a bad ground or a direct short to ground.

The only other ground...
Forum: S4 / RS4 (B5 Platform) Discussion
03-02-2009, 05:26 PM
Replies: 9
Views: 1,016
Posted By QCRAZY

Re: Done that - seems ok

Just so I'm clear...I'm talking about the ground connection under the battery (not on the battery). Clean it up and use di-electric grease to make sure it is a good connection.

Good luck!
Showing results 1 to 25 of 499
 
Page 1 of 20
1
2
3
11
Last »


 
Forum Jump


All times are GMT -8. The time now is 03:22 AM.