AudiWorld Forums

 
Page 1 of 8
1
2
3
Last »
Search: Posts Made By: HBAudi
Showing results 1 to 25 of 182
Search took 0.14 seconds.
Forum: A4 (B5 Platform) Discussion
06-14-2011, 09:26 PM
Replies: 19
Views: 20,020
Posted By HBAudi

wheel bearing noise?

At the risk of getting into yet another protracted debate on this forum, it has been my experience that simply replacing the rear wheel bearings may not be all that is needed. Given the age of most...
Forum: A4 (B5 Platform) Discussion
06-13-2011, 01:03 PM
Replies: 5
Views: 505
Posted By HBAudi

Unless you feel adventurous, here are two changes...

Unless you feel adventurous, here are two changes to consider using to replace the procedure 'Dr Bob' lays out:

Instead of disconnecting the fuel pump outlet and attempting to 'catch' the escaping...
Forum: A4 (B5 Platform) Discussion
06-12-2011, 08:33 PM
Replies: 16
Views: 20,077
Posted By HBAudi

Please help, 2.8 won't start.

Since you have no record of it being done, your mechanic should most likely begin with replacing the timing belt and associated parts after checking the valve timing and chain tensioners.
Forum: A4 (B5 Platform) Discussion
06-12-2011, 08:21 PM
Replies: 19
Views: 20,020
Posted By HBAudi

wheel bearing noise?

If you operate the vehicle in an area where corrosive salt is used on the roads in winter, the lower wheel bearing carrier bushing should also be replaced if the bolt was corroded in place.

When a...
Forum: A4 (B5 Platform) Discussion
06-12-2011, 12:24 PM
Replies: 16
Views: 20,077
Posted By HBAudi

Has the timing belt been replaced on this engine...

Has the timing belt been replaced on this engine recently and the timing chains/tensioners inspected if it is a 5-valve engine?
Forum: A4 (B5 Platform) Discussion
06-12-2011, 10:10 AM
Replies: 16
Views: 20,077
Posted By HBAudi

Please help, 2.8 won't start.

It can become quite expensive guessing as to which parts to replace. Connect the vehicle to a VAG-COM interface and software and you can determine if there are any codes stored in the system and...
Forum: 12v V6 Discussion
06-11-2011, 12:48 PM
Replies: 3
Views: 2,836
Posted By HBAudi

Help... cam is 180 degrees off

The quickest way to rotate the camshaft with the head installed on the engine without causing damage to the valves is to loosen the camshaft bearing caps.
Forum: A4 (B5 Platform) Discussion
06-11-2011, 12:42 PM
Replies: 4
Views: 27,108
Posted By HBAudi

Where is the clutch bleed screw located and how to access it?

The quickest and easiest way to remove the LH axle heat shield is through the wheel arch with the road wheel removed.

It is always good practice to have the vehicle supported securely on stands...
Forum: 12v V6 Discussion
06-11-2011, 11:51 AM
Replies: 5
Views: 10,108
Posted By HBAudi

Power Steering Pump and Pulley replacement

When reinstalling the pump outlet 'banjo' fitting and the suction hose fitting, it is always a good practice to replace the crush washers with new ones. You can use either aluminium or copper to...
Forum: A4 (B5 Platform) Discussion
06-11-2011, 11:37 AM
Replies: 4
Views: 27,108
Posted By HBAudi

Where is the clutch bleed screw located and how to access it?

The bleed fitting for the clutch hydraulics is located on the LH side of the gearbox just above the LH drive axle heat shield on the slave cylinder. I have found removing the heat shield, which is...
Forum: A4 (B5 Platform) Discussion
06-09-2011, 07:08 PM
Replies: 5
Views: 5,946
Posted By HBAudi

Replacing the Starter of the '97 1.8t Quattro

Your mechanic is correct. The front bumper must be removed and the front carrier placed into the service position to gain access to all the bolts. Removal of the starter motor also requires moving...
Forum: A4 (B5 Platform) Discussion
06-09-2011, 03:45 PM
Replies: 28
Views: 9,659
Posted By HBAudi

All they really do is provide the driver with a...

All they really do is provide the driver with a satisfying sound experience on acceleration.
Forum: A4 (B5 Platform) Discussion
06-06-2011, 11:45 AM
Replies: 19
Views: 20,020
Posted By HBAudi

wheel bearing noise?

The wheel bearing will allow the tire/wheel assembly to move when the tire is held by at the top and bottom in the '12 and 6' o'clock positions. If the wheel bearing has been worn for some time, the...
Forum: A4 (B5 Platform) Discussion
06-05-2011, 09:39 PM
Replies: 4
Views: 14,598
Posted By HBAudi

Help. Brake rotor is stuck

Since you have been 'smacking' the disc and hub, get ready to replace the wheel bearing shortly. So to that end, when reassembling the disc to the hub, smear a SMALL amount of anti-seize compound...
Forum: A4 (B5 Platform) Discussion
06-04-2011, 08:23 PM
Replies: 5
Views: 1,173
Posted By HBAudi

AWD humming????

When the clutch was replaced, did you also replace the flywheel? If the original flywheel was reused, there is a strong possibility the flywheel may be the cause of the 'wheel hop' you describe.
...
Forum: A4 (B5 Platform) Discussion
06-03-2011, 08:07 PM
Replies: 5
Views: 1,173
Posted By HBAudi

AWD humming????

The 'wheel hop' you describe can also be caused by the flywheel if the dual-mass springs have become weak or broken. When was the clutch replaced? Does the vehicle exhibit any different...
Forum: A4 (B5 Platform) Discussion
06-03-2011, 05:59 PM
Replies: 12
Views: 2,271
Posted By HBAudi

thinking of buying a used A4

If you can avoid purchasing a vehicle from the New York and New Jersey area it would be better in the long run. Apparently that area is known for the use of corrosive salt on the roads in winter.
...
Forum: A4 (B5 Platform) Discussion
06-03-2011, 05:49 PM
Replies: 5
Views: 1,173
Posted By HBAudi

AWD humming????

Based on your description of the noise/vibration, it could be a rear wheel bearing or a centre drive shaft bearing. Does you vehicle have a manual gearbox or is it an automatic?

Due to the number...
Forum: A4 (B5 Platform) Discussion
05-30-2011, 07:22 AM
Replies: 11
Views: 1,516
Posted By HBAudi

Rookie shopping for A4, advice?

Well said indeed!
Forum: A4 (B5 Platform) Discussion
05-30-2011, 07:03 AM
Replies: 5
Views: 27,445
Posted By HBAudi

There is no shortage of suspension options for...

There is no shortage of suspension options for the B5 platform. Depending on the type of driving you do and ride quality you can put up with, there are many choices to make. What has worked well...
Forum: A4 (B5 Platform) Discussion
05-30-2011, 06:47 AM
Replies: 11
Views: 1,516
Posted By HBAudi

Rookie shopping for A4, advice?

As you look at the vehicles, also pay attention to any modifications the previous owner may have done. The B5 platform, especially the 1.8L and later 2.8L models, are popular with 'tuners' who may...
Forum: A4 (B5 Platform) Discussion
05-30-2011, 06:25 AM
Replies: 11
Views: 1,516
Posted By HBAudi

Rookie shopping for A4, advice?

Conventional logic is to always look for a vehicle with low miles/kilometres. Although having a vehicle that has been driven less than normal distances each year may seem like a good idea, consider...
Forum: A4 (B5 Platform) Discussion
05-29-2011, 01:34 PM
Replies: 5
Views: 27,445
Posted By HBAudi

How can you tell if you have sports suspension?

There is a sticker with all the build-codes in the compartment that houses the spare tire. It is on the loser RH side of the body and can be cross-referenced with the Bentley shop manual...
Forum: A4 (B5 Platform) Discussion
05-28-2011, 07:55 AM
Replies: 4
Views: 1,441
Posted By HBAudi

If the system is still providing cold air when...

If the system is still providing cold air when the compressor is cycling on and off repeatedly, the system may be experiencing a restriction on the high pressure side. The in-line filter can become...
Forum: A4 (B5 Platform) Discussion
05-28-2011, 07:41 AM
Replies: 14
Views: 11,353
Posted By HBAudi

Front Control Arms - Lessons Learned

Perhaps you will be fortunate enough to not have one of the control arm castings fail; looking at their appearance is no indication of the casting quality. Both Meyle and Ocap conform to TUV and ISO...
Showing results 1 to 25 of 182
 
Page 1 of 8
1
2
3
Last »


 
Forum Jump


All times are GMT -8. The time now is 01:29 PM.