Search: Posts Made By: SoCal Avanti
Showing results 1 to 25 of 458
Search took 0.58 seconds.
08-03-2009, 11:33 AM
Replies: 0
Views: 708
Posted By SoCal Avanti

'96 Avant rear hatch actuator wanted

I don't know if they are all the same, but I need one for the hatch. If anyone has a good one just lying around that they can send me at a reasonable cost, please let me know.
05-25-2009, 08:14 AM
Replies: 1
Views: 4,037
Posted By SoCal Avanti

C4 A6 Front Wheel Bearing Press Tool?

Does anyone know if the tool to press out/in the front wheel bearing is available at Autozone to borrow, or do I have to either buy the whole kit from a place like Harbor Freight, or have it pressed...
11-26-2008, 09:22 AM
Replies: 4
Views: 304
Posted By SoCal Avanti

Almost looked like pre-ignition

The fuel looked like it was burning a fair amount of time before the piston reached the top of it's stroke... But then maybe I just don't know enough about an internal combustion engine to know what...
11-17-2008, 01:14 AM
Replies: 5
Views: 613
Posted By SoCal Avanti

Yes it is and the replacement steps are in the C4...

Yes it is and the replacement steps are in the C4 FAQs
11-09-2008, 08:51 AM
Replies: 8
Views: 635
Posted By SoCal Avanti

Which radio?

Which radio?
10-27-2008, 05:45 PM
Replies: 9
Views: 407
Posted By SoCal Avanti

My '96 Avant will be for sale soon... not as um...pretty as this one though.

Casablanca white/Ecru, 2001 S4 wheels, Urs4 springs. 174K. Tint. How much you got to spend? Make me an offer...
10-27-2008, 05:38 PM
Replies: 6
Views: 438
Posted By SoCal Avanti

Rad prob

I had that problem with the fan on my '96, and all it was, was a bad connection at the sender- looking down, along the right side near the bottom of the radiator on the engine side. Clean/repair the...
10-24-2008, 08:11 AM
Replies: 16
Views: 727
Posted By SoCal Avanti

Where are your headlight washers?

Where are your headlight washers?
10-12-2008, 06:33 PM
Replies: 3
Views: 5,006
Posted By SoCal Avanti

I'm talking about physical size.

I'm talking about physical size.
10-12-2008, 04:12 PM
Replies: 3
Views: 5,006
Posted By SoCal Avanti

What's the C4 A6 battery size/series?

What's the C4 A6 battery size/series?
10-07-2008, 10:02 AM
Replies: 14
Views: 1,102
Posted By SoCal Avanti

Anyone have one in So Cal available for loan?

Anyone have one in So Cal available for loan?
10-07-2008, 10:01 AM
Replies: 14
Views: 1,102
Posted By SoCal Avanti

From where? Autozone?

From where? Autozone?
10-06-2008, 03:07 PM
Replies: 14
Views: 1,102
Posted By SoCal Avanti

Front bearing removal on a '96 Avant

Does anyone know if you can press the bearing out without disconnecting the suspension(tie rod end, ball joint, etc)? Obviously the axle needs to be out of the spindle.
09-27-2008, 08:58 AM
Replies: 5
Views: 402
Posted By SoCal Avanti

I just threw up a little bit in my mouth...

I just threw up a little bit in my mouth...
09-25-2008, 11:00 PM
Replies: 11
Views: 2,253
Posted By SoCal Avanti

Yup. Me too. No tool, no problem if you know what...

Yup. Me too. No tool, no problem if you know what you're doing.
09-23-2008, 09:25 AM
09-16-2008, 09:30 AM
Replies: 1
Views: 411
Posted By SoCal Avanti

It'll make an amazing daily driver. Very nice.

It'll make an amazing daily driver. Very nice.
09-06-2008, 09:11 AM
Replies: 8
Views: 526
Posted By SoCal Avanti

Everything is connected. The pump runs when cold.

The only error I get is for bank one, so,....
09-06-2008, 07:32 AM
Replies: 8
Views: 526
Posted By SoCal Avanti

Can anyone suggest what to look for to fix the insuficient flow problem?

I realize that I need to take care of this, I just hope that it is just a loose hose or something minor...
09-05-2008, 05:10 PM
Replies: 8
Views: 526
Posted By SoCal Avanti

Ok, so I just failed my smog check. Grrrrrrrr.

Everything went fine, until the very end. The reason was: "This vehicle failed the MIL/Check Engine Light Test due to failure to successfully complete all OBD self tests" The tech asked if the car...
08-29-2008, 08:21 PM
Replies: 3
Views: 306
Posted By SoCal Avanti

Um... Eeeewwww.

Um... Eeeewwww.
08-16-2008, 07:30 PM
Replies: 5
Views: 390
Posted By SoCal Avanti

Crap that's a lot for a tool I'll probably only use once...

There must be someone who has one just collecting dust on a shelf.. Sell it to me cheap or let me borrow it.. It's a good karma thing...
08-16-2008, 08:38 AM
Replies: 5
Views: 390
Posted By SoCal Avanti

Can you give me the part # of the tool/s you bought for the job?

-And if they are available to rent/loan? :)
08-15-2008, 07:50 AM
Replies: 5
Views: 390
Posted By SoCal Avanti

Front bearing walk-through?

I was hoping that there would be a front wheel bearing replacement procedure explained somewhere already posted, but I didn't see one. Can someone point me in the right direction? Didn't someone have...
07-28-2008, 12:06 PM
Replies: 2
Views: 507
Posted By SoCal Avanti

You should probably ask the C5 forum....

You should probably ask the C5 forum....
Showing results 1 to 25 of 458
 


 
Forum Jump


All times are GMT -8. The time now is 09:48 AM.