Search: Posts Made By: quattro20v
Showing results 1 to 25 of 497
Search took 1.12 seconds.
11-02-2009, 06:32 PM
Replies: 10
Views: 1,674
Posted By quattro20v

carbon fiber trim non-air bag sport steering...

carbon fiber trim
non-air bag sport steering wheel
cloth seats
motors for headlights and switch in dash
springs
rear sway bar
08-06-2009, 07:20 AM
Replies: 4
Views: 730
Posted By quattro20v

Dave is correct, they are held in with a hex head...

Dave is correct, they are held in with a hex head bolt.
07-16-2009, 07:39 AM
Replies: 61
Views: 5,388
Posted By quattro20v

According to Hoppen's website, sounds like Stage...

According to Hoppen's website, sounds like Stage 2 which was 285 HP. If it has a 3 bar sensor, then the claimed was 295 HP.

I found this by using a web archiver for www.hoppenmotorsport.com from...
07-14-2009, 10:13 AM
Replies: 7
Views: 2,214
Posted By quattro20v

#10 on the first image, plus the end links. On...

#10 on the first image, plus the end links. On the end links, the Meyle replacement is poor quality, which is no where near OEM quality. Try and find a good used end link.
07-13-2009, 11:00 AM
Replies: 7
Views: 2,883
Posted By quattro20v

Sounds like a small split in the MM hose which...

Sounds like a small split in the MM hose which opens up under full boost.
07-08-2009, 06:43 PM
Replies: 13
Views: 6,320
Posted By quattro20v

Hey Nate: Do you sell 993tt rotor rings?...

Hey Nate:

Do you sell 993tt rotor rings? Looking for some for my Audi S6 which uses a custom hat and 993tt caliper with RS2 brackets.
07-06-2009, 04:04 PM
Replies: 2
Views: 1,867
Posted By quattro20v

Good work. Perhaps check the hydraulic fluid...

Good work.

Perhaps check the hydraulic fluid level and inspect the high pressure hoses and consider changing the coolant.

My only advice is to ditch the K&N air filter and use an OEM filter...
06-30-2009, 09:33 AM
Replies: 3
Views: 719
Posted By quattro20v

Likely MTM. Maybe IA and TAP.

Likely MTM. Maybe IA and TAP.
06-26-2009, 11:24 AM
Replies: 17
Views: 2,325
Posted By quattro20v

They are a PITA if the previous monkey wrench...

They are a PITA if the previous monkey wrench overtightened the plug and or didn't bother to use a new copper seal.

The torque setting on the drain plug is quite low, about 20 ft-lbs IIRC.
06-21-2009, 07:56 AM
Replies: 4
Views: 7,999
Posted By quattro20v

The part number from my list says 4D0 407 625E,...

The part number from my list says 4D0 407 625E, which doesn't show up as a single part for the C4 AAN, but interestingly shows up for the S6+, C5 A6, even the RS2.

The part numbers quoted in ETKA...
05-29-2009, 08:46 AM
Replies: 10
Views: 2,013
Posted By quattro20v

If you want to use the 92 sway bar, you will need...

If you want to use the 92 sway bar, you will need the 92 subframe as it has little "ears" which are the mounting points for the swaybar.

Drilling and tapping the wheel housings is no biggie.
...
05-11-2009, 07:45 PM
Replies: 28
Views: 4,458
Posted By quattro20v

Seems high for stock. What kind of dyno?

Seems high for stock. What kind of dyno?
05-10-2009, 08:42 AM
Replies: 3
Views: 12,177
Posted By quattro20v

The drain plug is just behind the exhaust...

The drain plug is just behind the exhaust downpipe where it crosses over the underside of the transmission. The fill plug is on the driver's side, just forward of the inboard CV joint.

Make sure...
05-09-2009, 08:27 AM
Replies: 13
Views: 1,478
Posted By quattro20v

Usually a boost leak will be way more noticeable...

Usually a boost leak will be way more noticeable than a slight loss of power (50 as you estimate). It may be a slight boost leak that occurs only under certain conditions.

Have you pulled the...
04-25-2009, 06:49 AM
Replies: 5
Views: 1,384
Posted By quattro20v

There should be a tab on the drivers side that...

There should be a tab on the drivers side that bolts up to the a stud on the compressor.
04-14-2009, 07:01 AM
Replies: 8
Views: 34,500
Posted By quattro20v

That's a good idea to use the 2079 and 7A snub...

That's a good idea to use the 2079 and 7A snub mount, the 2079 tool is much cheaper than the 3256.



A 1/2 drive is not strong enough to handle the torque, you are applying >600 ft-lbs to remove...
04-13-2009, 07:04 PM
Replies: 15
Views: 11,498
Posted By quattro20v

Very nice. Now how about a 1994 S4 with a AAN?...

Very nice. Now how about a 1994 S4 with a AAN? That would be a hot car here in Canada.
04-09-2009, 05:52 PM
Replies: 14
Views: 1,597
Posted By quattro20v

You can get the european sport springs which are...

You can get the european sport springs which are designed specifically for the Avant. They are available from Europrice. Combined with Boge Turbo Gas would make a nice ride for a daily driver.
04-05-2009, 08:35 AM
Replies: 2
Views: 979
Posted By quattro20v

to pick up the signal from the crank position...

to pick up the signal from the crank position sensor.
04-03-2009, 04:03 PM
Replies: 5
Views: 1,217
Posted By quattro20v

I don't believe this can be done without the...

I don't believe this can be done without the VAG-COM
04-03-2009, 07:36 AM
Replies: 0
Views: 2,531
Posted By quattro20v

Turbo and exhaust manifold glowing red

On the way home last night on a long freeway stretch, I was playing with a new IS 350 and when I got home I popped the hood to let the engine cool and saw the turbo and exhaust manifold glowing red....
04-02-2009, 07:02 AM
Replies: 25
Views: 2,063
Posted By quattro20v

Its #3 in the attached photo and yes, there is a...

Its #3 in the attached photo and yes, there is a special tool called a 2069. The 2069 tool has a pentagon shape that engages in a matching shape inside the cap. I have one, but honestly a large pipe...
04-01-2009, 06:31 PM
Replies: 25
Views: 2,063
Posted By quattro20v

It's not a nut, its round and about 2.5 inches in...

It's not a nut, its round and about 2.5 inches in diameter.
03-31-2009, 09:43 AM
Replies: 25
Views: 2,063
Posted By quattro20v

[QUOTE=Chapel;23754992]Also, is the strut cap nut...

[QUOTE=Chapel;23754992]Also, is the strut cap nut that slotted piece of sh!t like a VW? I have that if it is.[QUOTE]

No, the strut cap nut is not slotted. You will need a big pipe wrench to get...
03-28-2009, 07:41 AM
Replies: 7
Views: 56,548
Posted By quattro20v

Looks like it may be engine oil mixing with the...

Looks like it may be engine oil mixing with the coolant, which can be caused by a blown head gasket. Check your dipstick to see if you see if the oil is light brown color, if so, your head gasket has...
Showing results 1 to 25 of 497
 


 
Forum Jump


All times are GMT -8. The time now is 11:49 PM.