So, I dropped my car off with Tony@EPL last friday. Here's what's being done for v2 of the software:

1) X-1 intake to be installed
2) wastegate actuator to be adjusted
3) New catchcan (see pic below)
4) Programming 23-25psi to redline (93 octane)
5) programming 23-25psi to redline (100 octane)and Aquamist with 50/50 mix of water/meth) (1 gallon of blue windsheild washer fluid and two 12oz bottles of HEET)

Here's what was done since I was tuned 2 months back:
Completed - New Stoptech calipers and pads (2nd gen)
Completed - New tie rod end
Completed - New CV Boot
Completed - suspension adjusted
Completed - airbag fixed
Completed - exhaust leak fixed
PASS emissions/safety inspection


Once I get the car back, the only maintenance that I have left if rear wheel bearings....and clean up the engine bay.

new CF engine covers to match the X1 =)

There will be "lessons learned" post when I get my car back. Stand by.

---------------------------------------
Matt's Mad Beast: Blouch K04/997 hybrids, RS4 intake&cams with port-matched heads, 60lb injectors, the rest of the supporting cast
EPL Tuning v4.0 93oct 463whp (70F) April 2007
EPL Tuning v3.0 93oct 460whp (40F) Jan 2007
EPL Tuning v2.0 100oct 480whp Jan 2007
EPL Tuning v2.1 100oct program 06-23-2006
471whp @ 7000rpm, 449 lb/ft @4023 rpm

EPL Tuning v1 93oct progam 04-05-2006
418whp @ 7150rpm, 430 lb/ft @3853 rpm

EPL Tuning v1 93oct prog w/100oct (no adapt) 5-13-2006
437whp@6714 427wtorq@3884

Custom Tuned by EPL


picture poster part 1 picture poster part 2
picture poster part 3 picture poster part 4
Ask me why my last set of turbos blew