got a code saying EGT sensor 1 short ground or something similar. has anyone had this code and what
#1
got a code saying EGT sensor 1 short ground or something similar. has anyone had this code and what
excatly does it mean.
TIA
BTW REVO wants me to keep my software they now send me a new version of the stage 3 lil more aggresive and running close loop.
TIA
BTW REVO wants me to keep my software they now send me a new version of the stage 3 lil more aggresive and running close loop.
#3
Check data block 112.
should read 1035 with engine off, and 945 with engine running. Anything else, and that one's bad.
Send me your bad EGT sensor? The sensor itself is most likely fine, it's the black box with the circuitry that goes bad. So if you know of someone doing an EGT gauge setup, they can use that sensor. I'm putting one in each downpipe, and running a switch at my gauge so I can see each side......someday.
Send me your bad EGT sensor? The sensor itself is most likely fine, it's the black box with the circuitry that goes bad. So if you know of someone doing an EGT gauge setup, they can use that sensor. I'm putting one in each downpipe, and running a switch at my gauge so I can see each side......someday.
#4
by any chance do you know which is sensor one, red box(pass) or black(driver)
i believe is the pass but im not sure, the code is sensor 1 (g2s2) it think.
btw i also replace the CTS for the green one, missfires less but still does.
now this is a question to see if i can avoid buying a sensor. can i over pass the sensor with a resistor or not?
TIA
btw i also replace the CTS for the green one, missfires less but still does.
now this is a question to see if i can avoid buying a sensor. can i over pass the sensor with a resistor or not?
TIA
#7
I got a coed once that said something about me being too short down there or something:-(
Might have been a different coed than yours, though. At least, i sure hope it was a different coed.