ok, here are some logs from yesterday and today ..
#1
AudiWorld Super User
Thread Starter
Join Date: Dec 2002
Posts: 17,772
Likes: 0
Received 0 Likes
on
0 Posts
ok, here are some logs from yesterday and today ..
it took me a little to figure this thing out , i hope this is an ok job
i have couple q-s
1)what exactly is "O2S pre and post TWC " are these the O2 sensors per bank 1 = pass side and "b2 pre and post TWC" are the 02 sensors per bank 2 = driver side ?
2) looking at the "b2 pre TWC" ..seems to go on the low side- lean out a bit , but the other O2 sensor reads fine down stream - the "b2 post TWC" ... could that be a bad 1-st O2 sensor ?
it went even lower with the next run (second pic has 2 logs back to back 3-rd gear o2 sensor Voltages)
<img src="http://pictureposter.audiworld.com/47312/o2vlog.jpg">
<img src="http://pictureposter.audiworld.com/47312/2o2sensorlogs3-rdgear.jpg">
3) does the block 034 has the EGT for one side or an average for both sides ? seems pretty low and good/safe correct (on another 4-th gear log the egt went up to about 840 C) ?
<img src="http://pictureposter.audiworld.com/47312/egttemps.jpg">
4)how much can i adjust the timing based on my CF's ? there should be some room there i see (and per DAP
<img src="http://pictureposter.audiworld.com/47312/cfs.jpg">
and finally here is the boost nice and flat and the knock voltages :
<img src="http://pictureposter.audiworld.com/47312/boost.jpg">
<img src="http://pictureposter.audiworld.com/47312/knockvoltage.jpg">
i have couple q-s
1)what exactly is "O2S pre and post TWC " are these the O2 sensors per bank 1 = pass side and "b2 pre and post TWC" are the 02 sensors per bank 2 = driver side ?
2) looking at the "b2 pre TWC" ..seems to go on the low side- lean out a bit , but the other O2 sensor reads fine down stream - the "b2 post TWC" ... could that be a bad 1-st O2 sensor ?
it went even lower with the next run (second pic has 2 logs back to back 3-rd gear o2 sensor Voltages)
<img src="http://pictureposter.audiworld.com/47312/o2vlog.jpg">
<img src="http://pictureposter.audiworld.com/47312/2o2sensorlogs3-rdgear.jpg">
3) does the block 034 has the EGT for one side or an average for both sides ? seems pretty low and good/safe correct (on another 4-th gear log the egt went up to about 840 C) ?
<img src="http://pictureposter.audiworld.com/47312/egttemps.jpg">
4)how much can i adjust the timing based on my CF's ? there should be some room there i see (and per DAP
<img src="http://pictureposter.audiworld.com/47312/cfs.jpg">
and finally here is the boost nice and flat and the knock voltages :
<img src="http://pictureposter.audiworld.com/47312/boost.jpg">
<img src="http://pictureposter.audiworld.com/47312/knockvoltage.jpg">
#4
Pre-cat 02 sensors and post-cat 02 sensors. B1 is passenger side and B2 is driver side IIRC.
You want to pay most attention to the front sensors (S1 on each bank).
Do you have a TCD? What were the weather conditions?
Do you have a TCD? What were the weather conditions?
#6
AudiWorld Super User
Thread Starter
Join Date: Dec 2002
Posts: 17,772
Likes: 0
Received 0 Likes
on
0 Posts
TCD and about 75 degrees outside temp... i don't know why that sensor shows so low
you can see the sensor down stream on the same side show up ok..could it be the sensor going ?
i would think that if the mix would go toward the leaner side the post TWC sensor on the same side would show low also ..but it does not .
i would think that if the mix would go toward the leaner side the post TWC sensor on the same side would show low also ..but it does not .
Trending Topics
#10
AudiWorld Super User
Thread Starter
Join Date: Dec 2002
Posts: 17,772
Likes: 0
Received 0 Likes
on
0 Posts
i'll put 2 new ones in (the primary ones - the most important)
the temps (A/F ratio) was my main concern besides eventual boost leaks ..that i don't have.
thanks for the tips and help doc !
thanks for the tips and help doc !