urq front driveshafts
#1
AudiWorld Senior Member
Thread Starter
Join Date: Mar 2000
Posts: 680
Likes: 0
Received 0 Likes
on
0 Posts
urq front driveshafts
Are these still available? Are 5kt's the same units? Help, in the middle of a 5 bolt swap on an 86 4kq, hoping to hang urq 5 bolt strut assemblies on here but looking for the right fit axlewise....
Any insight would be appreciated...
Thanks
Any insight would be appreciated...
Thanks
#3
If you keep original 4kq tranny you need 4kq axles from 1985.5 up....
Those use large outer joints but 100mm inner joints. Ur-q uses 108mm inner joints so even if you find some axles you will need to swap the tranny output flanges to match.
Hope this helps.
Hope this helps.
#6
You mean Ur-q joints on 4kq axles? SImple answer is no....
The shafts have different splines, not only that the 4kq CVs simply knock off with a hammer, the large Ur-q stuff has a circlip that needs to be opened before CV is released.
When you see them side by side there is a big difference in the shaft size.
Hope this helps.
When you see them side by side there is a big difference in the shaft size.
Hope this helps.
Trending Topics
#8
Re: You mean Ur-q joints....
Sort of..I'm looking to mate the late 86 4kq 4 bolt hubs up to early 83 urq axles.
It sounds as though the outer splines are the same though from what you told Aldo...( late 85.5 4kq axles but need to swap the inner urq hubs due to 108mm as opposed to 100mm inner joints) to do a 5 bolt swap.
Will the outer late 85.5 4kq joint fit the outer early urq hub?
Thanks.
It sounds as though the outer splines are the same though from what you told Aldo...( late 85.5 4kq axles but need to swap the inner urq hubs due to 108mm as opposed to 100mm inner joints) to do a 5 bolt swap.
Will the outer late 85.5 4kq joint fit the outer early urq hub?
Thanks.