Audi Center cap that fits Porsche Wheels?
#1
AudiWorld Junior Member
Thread Starter
Audi Center cap that fits Porsche Wheels?
I recently purchased some 20" Sport Design Cayenne wheels and looking to replace the centercaps with Audi caps. Does anyone know if there are Audi centercaps that fit? I believe the Porsche centercaps are 76mm but I cant seem to find Audi ones in that size.
I'm also trying to find the weight of the 2013 OEM 20" wheels, hoping the Sport Design wheels are lighter
I'm also trying to find the weight of the 2013 OEM 20" wheels, hoping the Sport Design wheels are lighter
#2
AudiWorld Senior Member
ECS says they are 78mm and these should fit.
https://www.ecstuning.com/Search/4L0...aign=postreply
from this thread.
https://www.audizine.com/forum/showt...di-center-caps
https://www.ecstuning.com/Search/4L0...aign=postreply
from this thread.
https://www.audizine.com/forum/showt...di-center-caps
The following 2 users liked this post by Pothole5000:
dreadlocks (02-08-2021),
stepinrazor (02-08-2021)
#5
#7
AudiWorld Junior Member
Thread Starter
So I ordered some off eBay. Look like OEM knockoffs and the outside diameter fits perfect but the inside diameter does not fit. So it looks like the Audi 78mm caps do not work on Porsche wheels.
Im going to have to see if I can McGyver the Audi caps to work.
Im going to have to see if I can McGyver the Audi caps to work.
Trending Topics
#8
Just found these on eBay while searching for winter wheels - https://www.ebay.com/itm/2007-2008-2...kAAOSw-QtfPueD
#10
AudiWorld Junior Member
Thread Starter
Update on the center caps.
So I bought these on ebay cause they looked like OEM knockoffs and were 77mm: https://www.ebay.com/itm/Set-of-4-77...72.m2749.l2649
When I tried to swap them out they wouldn't fit because the inside diameter was too big, so they could not completely fit in and 'snap' in.
Picture below for comparison (outer diameter was perfect):
Inner diameter however is not:
So I just took some wire clippers and clipped off all the inner parts
And it fit pretty good, it's not being held on by anything behind to keep them clipped in, but I cant take them out unless I try to pry them out with something sharp. I'll chime back in after some miles to let everyone know if they stay on
So I bought these on ebay cause they looked like OEM knockoffs and were 77mm: https://www.ebay.com/itm/Set-of-4-77...72.m2749.l2649
When I tried to swap them out they wouldn't fit because the inside diameter was too big, so they could not completely fit in and 'snap' in.
Picture below for comparison (outer diameter was perfect):
Inner diameter however is not:
So I just took some wire clippers and clipped off all the inner parts
And it fit pretty good, it's not being held on by anything behind to keep them clipped in, but I cant take them out unless I try to pry them out with something sharp. I'll chime back in after some miles to let everyone know if they stay on