Tail Light Assembly - Right Lower - 2015 SQ5
#1
AudiWorld Super User
Thread Starter
Tail Light Assembly - Right Lower - 2015 SQ5
Someone backed into the bumper & cracked the right rear tail light assembly. Anyone replace their's? Where is access to remove assembly? Assume it's a pop-out, un-clip connection, clip & pop-on new piece! I noticed on a Q7 you-tube that access was thru an opening on bumper (ie little plastic door)
15 2015 Audi Q5 Tail Light Assembly - Body Electrical - Action Crash, Automotive Lighting, Magneti Marelli, Left - Driver Side, Left Lower, Right - Passenger Side, Right Lower - PartsGeek
15 2015 Audi Q5 Tail Light Assembly - Body Electrical - Action Crash, Automotive Lighting, Magneti Marelli, Left - Driver Side, Left Lower, Right - Passenger Side, Right Lower - PartsGeek
Last edited by D3AeighT; 03-20-2017 at 07:29 AM.
#2
AudiWorld Member
Someone just did that to me also. I just ordered the part from that same place (mine was left side). When it arrives, I'll let you know how I installed it.
#3
AudiWorld Member
Very easy...
1.) Pop the tow hook covers off.
2.) Look up at an angle you will see a phillips head screw.
3.) Unscrew this (it is captive so it won't fall out) and you will be able to pull the light assembly in the bumper straight out.
4.) Undo connectors...
5.) Reverse the process.
Takes about 5 minutes.
1.) Pop the tow hook covers off.
2.) Look up at an angle you will see a phillips head screw.
3.) Unscrew this (it is captive so it won't fall out) and you will be able to pull the light assembly in the bumper straight out.
4.) Undo connectors...
5.) Reverse the process.
Takes about 5 minutes.
#4
AudiWorld Member
Very easy...
1.) Pop the tow hook covers off.
2.) Look up at an angle you will see a phillips head screw.
3.) Unscrew this (it is captive so it won't fall out) and you will be able to pull the light assembly in the bumper straight out.
4.) Undo connectors...
5.) Reverse the process.
Takes about 5 minutes.
1.) Pop the tow hook covers off.
2.) Look up at an angle you will see a phillips head screw.
3.) Unscrew this (it is captive so it won't fall out) and you will be able to pull the light assembly in the bumper straight out.
4.) Undo connectors...
5.) Reverse the process.
Takes about 5 minutes.
#5
AudiWorld Member
Took less than 5 min, including pulling the car into the garage. Remove be small panel, loosen screw, pull out light. Do the reverse and your good to go. The new light even came with the bulbs already.
#6
AudiWorld Super User
Thread Starter
Agree
I placed order for part, came next day, replaced in 5 minutes as well. Replacement part had the same #'s as OEM but the lable on the part was scratched off somewhat to hide complete details of part #'s! Works & looks great!
Thread
Thread Starter
Forum
Replies
Last Post
josepeter22
Q5/SQ5 MKI (8R) Discussion
8
08-05-2016 08:09 AM