MAF fault code 16486, need some advice please!...
I just logged a 16486 Mass Air Flow Sensor (G70): Signal too Low code. I got the MAF replace under waranty about 7 months ago. The car still pulls ok, seems like a bit of hesitation but it doesnt pull as hard as it has in the past. I dont htink its in limp mode but its not as fast as it shoudl be.
The link below is a link to a psot i found. THis guy had the exact (almost word for word) problem i had. HEard a poping noise, no power, then power back on with CEL. I have replaced my TTB with Samco. Could it have been becasue i havent cleaned my forge BPV in a while? Thanks guys Brian<ul><li><a href="https://forums.audiworld.com/s4/msgs/156527.phtml">https://forums.audiworld.com/s4/msgs/156527.phtml</a</li></ul> |
no reason why this MAF isn't failing as well. are you under warranty?
|
No i am not under waranty, but the MAF is. I have already got it replaced under waranty 7 months ago
|
Mine blew after driving 5 miles on a new one which was replaced under warranty!! more...
unplug the Maf sensor wire and see if it smooths out...if it does then time to get a new MAF!
|
All times are GMT -8. The time now is 01:10 PM. |
© 2024 MH Sub I, LLC dba Internet Brands