Remote FOB Key Programming Instructions
Programming remote unit
- Switch ignition ON. - Lock vehicle mechanically at left front door using second key. - Press "Open" button on first remote unit (key fob) once (to assign memory address to remote unit number one). Note: The alarm horn will sound briefly each time the "Open" button is pressed to confirm the reception of the signal during this process. - Wait six seconds after sending last signal, then press "Open" button again. ^ Doors will now unlock (remote unit is now programmed). - Lock vehicle mechanically again using second key. - Press "Open" button on second remote unit (key fob) twice at 1 second intervals (to assign memory address to remote unit number two). - Wait six seconds after sending last signal, then press unlock button again. ^ Doors will now unlock (2nd transmitter is now programmed). - Repeat procedure for additional remote units (key fobs) to assign memory addresses number 3 and 4 if necessary. - Switch ignition OFF. - Check each transmitter for proper function |
All times are GMT -8. The time now is 01:41 AM. |
© 2024 MH Sub I, LLC dba Internet Brands