sumang24

<center><img src="http://f2.pg.photos.yahoo.com/ph/kevin_ny_2003/my_photos"></center><p>All,

I need help with this urgently. My cars turn signals are not blinking. I found out that problem may be in the Flasher relay for the turn signal which is inbuilt in the Harzard Switch. I was able to remove the red triangle on the hazard switch but after that I am stuck. I don't know how to take the rest of the part out. I am
posting a link to the pic of the same.

If anyone has a bentley manual for Audi A6 , please send me the instructions to replace the hazrad switch. My car's state inspection is due and it will not pass the inspection without getting this thing working.


Thank You for your help.<ul><li><a href="http://f2.pg.photos.yahoo.com/ph/kevin_ny_2003/my_photos">http://f2.pg.photos.yahoo.com/ph/kevin_ny_2003/my_photos</a</li></ul>

want

<img src="http://pictureposter.audiworld.com/56080/switch_in_center_console.jpg">
Switches in center console, removing and installing

Removing
- Carefully pry off trim panel -1- using flat screwdriver.
- Pull required switch -2- all the way out and disconnect electrical connector.

Installing
- Reconnect electrical connector.
- Push switch into recess and snap into place.

ThomHart

not to scratch up the cover plate, it's $110. If the clips break off, just epoxy them back on.

sumang24

Thank You very much for sending the instructions. I was able to replace the part. The part only costed me $32.00 including shipping and handling from Audi Dealership.

This is a great forum.!!

Suman