1-2 above rear bumper corrosion & fix AUDI V8
#1
AudiWorld Senior Member
Thread Starter
Join Date: Sep 2003
Location: Ottawa, Canada
Posts: 1,718
Likes: 0
Received 0 Likes
on
0 Posts
1-2 above rear bumper corrosion & fix AUDI V8
hey there I thought I would post some picture of a repair i did. Note that this was a metal replacement, with very little bondo. Here are the first five pictures of ten.
picture one, is the start, you can see a little corriosion
picture two, once the grindding starts you can see how bad it is.
picture three,after gridding wholee frick!!!
picture four,cut bad metal out
picture five, old piece, new formed piece of metal
picture one, is the start, you can see a little corriosion
picture two, once the grindding starts you can see how bad it is.
picture three,after gridding wholee frick!!!
picture four,cut bad metal out
picture five, old piece, new formed piece of metal
#2
AudiWorld Member
Join Date: Apr 2009
Location: Richmond VT...spend a lot of time in Castiine Maine though.
Posts: 316
Likes: 0
Received 0 Likes
on
0 Posts
Looks good, I suspect ill be doing that one at least two of the cars cars this summer. Keep us posted on the finished product.
#3
AudiWorld Senior Member
Thread Starter
Join Date: Sep 2003
Location: Ottawa, Canada
Posts: 1,718
Likes: 0
Received 0 Likes
on
0 Posts
If I was to do the job again >>>> i'd go to a junk yard and find a good back end off of an Audi V8/100/200/5000 and replace the whole area.
#5
AudiWorld Senior Member
Thread Starter
Join Date: Sep 2003
Location: Ottawa, Canada
Posts: 1,718
Likes: 0
Received 0 Likes
on
0 Posts
yes get a nice little di-Grinder and you could cut the piece out very easily. did you see the finished product on the second post?
superdave
superdave
Thread
Thread Starter
Forum
Replies
Last Post
5000CDQturbo
Audi 5000 / 200 / V8 Discussion
3
03-14-2013 03:44 AM
capitolm94
S4 / RS4 (B5 Platform) Discussion
2
09-24-2002 07:18 AM