I was planning to install the factory '98 sport suspension I purchased tomorrow but after reading the service manual the rear setup looks like a problem to re-assemble without the special wiz-bang alignment tool. I have no accurate way to measure 22 degrees spring preload, nor keep it there while snugging everything up. Is this as hard and critical adjustment as it looks or is the manual making a mountain out of a mole hill.<p>

I heard you got the new chip from wett, How was it? Do you know how much boost come out from this chip suppose to be? Cause I got the new one too, but it only output not even 1 bar. Thats why I want to know your one. Thanks for your help..<br>

Please contact Wett on these issues. <p>I have a '97 and was shipped software for a '98 car so I can't comment

They both did the H&R coilovers.<p>Steve S.<br>97 2.8QM

I am going to install springs and shocks WITH a shop in my area, CT. I do not even have a shop manual. Can you fax relevant pages to 203.562.0095 or post highlights by 8 AM 10/31?<p>thank you

Seriously, I have no clue as to that, sicne there were no manuals out when I did my H&R's, but just make sure everything fits and lines up and I don't think you'll have a problem....<p>Enjoy gettiung the rears out, tho... it's quite the pain in the arse!<p>Rich Quinlan<ul><li><a href="http://home.att.net/~richquinlan">Quinland</a></li></ul>