So I'm trying to get the windows to roll up/down with the remote. I went to module 46 I think (Central Conv) and observed the value of 11788. I erased it and typed 11852 and hit recode. I can go back there now and observe that this new value is there. BTW: I did not see a "test" button or anything. Having done this, I still can't roll the windows up or down with the remote. What am I doing wrong or not doing? Do I need to start the car after recoding and drive it and then try again?

Thanks,
mike

I believe I'm supposed to see 95 in Adaptation #62, but nothing shows up. Should I just update it with 95?

...it may be an indication that the ECU in question will not display the information. I have seen a few examples of this recently, where the ECU shows no value no matter what channel is accessed.

Nevertheless, I believe Mike5 has resolved this with a VAD software update.

With a little time we'll figure out exactly what is going on!

How's that software working so far?

I did the VAD on a sedan from previous and I can read block 62 and others using both versions of the software. So I don't know if something weird was going on with my Palm or what (all I can point to). I will repeat this on the Avant as well to find out what happens.

Thanks,
Mike

I believe I'm supposed to see 95 in Adaptation #62, but nothing shows up. Should I just update it with 95?

Darrryl,

I'm having this problem also! This is Rory by the way with the 2003 A4 1.8TQ. I recoded it to 11884 and was able to get the autolock function to work but the windows won't go up with remote when i press the lock/unlock button. Could this be because i haven't done adaption 62 with a code of 95?

Darrryl,
I'm having this problem also! This is Rory by the way with the 2003 A4 1.8TQ. I recoded it to 11884 and was able to get the autolock function to work but the windows won't go up with remote when i press the lock/unlock button. Could this be because i haven't done adaption 62 with a code of 95?

Rory,

Please sned me an e-mail to darryl@vadpro.com with the applicable ECU P/N and I will check the procedure. The previous example was solved with a software update. As your version is up to date, I will look at other reasons. Thanks.

Thanks darryl will do over the weekend.

Thanks!