View Full Version : oem ride height question...


ArthurPE
12-31-2008, 12:12 PM
<center><img src="http://pictureposter.audiworld.com/154625/picture_007_rev.jpg"></center><p>
searched, no luck...any help would be appreciated

just measured mine...floor to fender lip @ wheel center...note the pic was taken on a sloped surface...the rear is lower by 6" or so...
so the front appears a bit higher and the rear lower due to wt transfer...

~3/8 tank of gas
avg F &amp; R 26-5/8"
very consistent
low ~26 8/16
high ~26 11/16

tires are ~26" OD so the gap is 5/8" even all around...

I did this because my car seems lower than photos I've seen..

yes, I checked the shocks, no leaks and no weird noises/handling when doing a sharp/fast downhill turn or over bumps...

Vijay
12-31-2008, 02:18 PM
That is with a full tank of gas and my 46lb sub/box/amp in the trunk

audi_dtw
12-31-2008, 03:00 PM

ArthurPE
12-31-2008, 03:07 PM
thnx...mine would seen normal then...

ArthurPE
12-31-2008, 03:19 PM
it's got a lens and some electronics &amp; stuff

it takes reflected photons and converts them to a digital image which can be manipulated/conveyed as a 'file' or finite set of bytes...
it can also be made to excite an LCD to emit photons in a pattern similar to the original excitation source...but distorted ;)

audi_dtw
01-01-2009, 05:11 AM