I installed PBR Ceramics and Zimmermans up front. Three days later, both sides started sqeaking. I did a Stoptech bed in procedure and that took care of the squeak on the driver's side but the passenger side still squeaked. I did a 2nd bed in and that didn't take care of the problem. I did a third bed in but with only three runs from 60 mph to 20 mph and they still squeak but not so much. I used ant-squeak during the install. Do you think a fourth bed-in would do the trick?

Performance notes: Other than the sweak, it's a great pad. Excellent bite even when they're hot. Dust-wise, much less than OEM-Lucas pads. I installed PBR/Zimms on the rears in Oct. and the difference in the amount of dust produced was noticeable.

I've tried everything; beveling the pad's edges, quiet compound, mutiple beddings. Fack it, i called rotorworks on Friday after 2 hours in stop and go traffic hell and they're sending the other pads today.

they don't make to much noise, on my old Jetta I had teh metal master ver of them they were great