Hi Everyone,

Just a few quick questions on a Sirius install before I get started. So I picked up a cheap receiver off of ebay for $100 - part #8E0 035 593 D. From reading through the tech article, this will work with my "Audi Symphony" / tire pressure sensor setup (please correct me if I'm mistaken).

Also, my '08 2.0t came 'prewired', so I assume that everything is there - including the antenna. Is this correct? All I need is the Sirius box?

Thanks again everyone!
Mark

in the truck on the drivers side is a panel, you need to open and pull the drawer out. The wires will be tucked up in the back, with a cap on the end that plugs to the Sirius unit. You may need to cut back the tape to pull in out far enough to plug it to the unit.

You'll also need to move the CanBus plug up on the passanger kick side panel. Again real simple, unplug move it over and plug it in..

the write up in the DIY is pretty spot on.

good luck and enjoy the new tunes.