How bad did I get beat? I got one control arm in the front, one tie rod on the front... Right front wheel bearing, left rear wheel bearing and some sensor that wasnt much money.. bill was 1200$ any comments?

if you were to DIY it would only cost about $250 for parts but when you buy them at retail its closer to $600 then you also have the labor so its not that bad .. not Great but you didnt get your hands dirty or bust up any knuckles..:)

Its got this click when you pull off. It kinda sounds like the brake caliper is sticking but its not. He's gonna take a look while I'm on vacation next week.