I have two 12V heads I need milled. Any suggestions?

Still working on the A6? Ouch...

Will I have to strip the head (remove cams, valves, etc.) to have it milled? I hope not, since I lapped the valves and replaced the stem seals last year.

If I don't find anything closer I'll ferry the heads up to your local place.

valves typically no.

I had these guys check out a couple of cars for me. Really knew what they were doing. One of the "Marks" is a former audi tech. More than reasonable rates and will talk audi as long as you have the time. I learned more from them in an hour than in my previous 12 years dabbling with vw/audis.

more likely than not, they send their stuff to R&L

good work at good prices. let me get the guys info and ill edit this post

EDIT:

Highland Ave Machining - Scott - 617-666-1450