View Full Version : Paging ar design or anyone else in Denver that could help pull some codes and is familiar with MTM


A4Huey
07-31-2008, 01:39 PM
and/or give some input on the whats going on with my Audi. So here is the deal, I installed an MTM stage 1+ chip with bosch injectors and my car run fine under "normal" driving however under load or hard acceleration above 70mph the car starts missing bad. I went camping last weekend and at high elevations it was so bad I could barely keep up with traffic and it seem to be guzzling gas. My boost gauge has only showed a slight change in the amount of boost after installing the chip.

Andrew aka ar designs was nice enough to stop by and check things right after install and verify the fuel trim settings Hoppen said to check, which appeared to be within range.
Andrew, if youre aroud this weekend and feel like lending a hand, i'd like to also try some real time loging too...so let me know, thanks.

Any opinions/ideas/help would be appreciated.

[Arawan]
07-31-2008, 04:26 PM

ar design
07-31-2008, 07:07 PM
I forgot to call you back....... Give me a call 303 990 3612

S4HORE
08-01-2008, 05:33 AM

A4Huey
08-01-2008, 09:08 AM
call it stage 2 or something