My digi-dash has been fried. I can repair most of it, but there is a coil about 1 inch long near the center of the board that is too badly blackened to get the markings off of it. Does anybody know the specs on this and/or a supplier? Or does someone have a busted digi they want to sell for parts? Thanks.

I was going to send one of my dashes to these guys, they said they have repaired them before . They may have more info

Adam @ 1-800-572-2880
Im not so much of a hurry any more because I had another working unit

good luck

Its hard to tell since the lettering is facing components that are only about 1mm away. The G looks a little goofy; kinda like a cross between a cap G and a cap Q. The "u" looks like the "u" used in the electronic shorthand for microfarad (uF).

That's the best I can do. Good luck!

CLICKY!!!<ul><li><a href="http://www.instrumentclusters.com/">http://www.instrumentclusters.com/</a</li></ul>

Thats helpful! Thank you! Need to get batts for the camera, but I'll try to post some pics and keep everyone updated if I'm successful.