<ul><li><a href="http://www.importdrag.com/images/tiltfront.jpg">http://www.importdrag.com/images/tiltfront.jpg</a</li></ul>

<ul><li><a href="http://www.importdrag.com/images/cornercut.jpg">http://www.importdrag.com/images/cornercut.jpg</a</li></ul>

some background for this pic..
*+notice first my nonsport steering wheel =(
*Apex'i boost gauge on a-pillar pod.. looking for matching fabric to cover it so itll blend with interior.. looks much better in the dark (boost gauge) indiglo backlight with red needle..
*Razo pedals - g h e t t o installation..
* notice the 2 green fog lights? one for the oem lights, and the other for my raybrig lights.. pretty trick eh? (thanks carlos)
*carbon/aluminum shift knob
*hands free startac
*turbo timer in right hand upper center compartment.<ul><li><a href="http://www.importdrag.com/images/interior.jpg">http://www.importdrag.com/images/interior.jpg</a</li></ul>

These are the modifications done to my 99 1.8TQM
18x8 avant garde design S
Neuspeed race springs
LLtek sport mirrors
Garrett 1bar
Raybrig Fogs
Clear corners and side markers
Kamei grill
35% tint
Apex'i turbo N1 muffler with 3" cat back piping
Apex'i boost gauge
Greddy turbo timer
HKS Super Sequential BOV
razo pedals
carbon/aluminum shift knob
K&N drop in
debadged
ppi pc1400
2 IDQ12's
and more...

I haven't been and it made me feel drunk. Sharp looking wheels though.

parkerpt
99.5 1.8t qms

ok.. first of all, you need a dremel.. and you cant be scared to cut up your bumper...
im sure that there are much easier ways of doing this.. but this is the way i did it..
if thats ok, then here it goes..
the fog lights i purchased were about 3" circular.. to make em fit i had to do a couple things..
#1 remove screw for bottom horn assembly. you're going to need to bend the bracket back and retrofit it to make room for the passenger side fog light..
i had to cut the upper portion of my bumper to make room for the light.. about a 2"x6" section..
once you get it in, bolt up the bottom bracket to the lower part of your bumper.. this is for both sides..
next, use the dremel to cut the plastic grills.. good luck, use white chalk to mark a circle..
wire em up.. and install..
go to your local audi dealership and buy a fog light switch.. use a voltmeter and figure out which terminals are power/dimmer/ground/etc..
if you need to know which terminals you'll need to use, i'll take pics of the back.. i think there were like 5 connectors on the back of the switch.. i'll check later..

to do this, you'll need to know how relays work.. how to wire em up.. which wires you'll need to tap into for power, accessory, etc..

if you dont have a working knowledge of this, call a professional.. if youre in jersey, i can recommend someone locally who can do this.. he's awesome! (nice plug eh carlos?)

good luck.. once again, if you do indeed decide to do this, please be very confident. the reason why i cut into my bumper was cuz eventually i knew that i'd be upgrading to a projectzwo or rs bumper..

hope this helps..

one thing tho.. my visabilty in poor weather and dark roads is much better now..

brian

<center><img src="http://131.107.68.28/a4org/tiltfront1.jpg"></center><p>Now you don't have to get dizzy lookin at the picture...

Steve S.