So I know of the rear tow point on our cars. And I seem to recall there was a front Eye Bolt that "use" to come out of the front lower-grill "before" I put the FMIC on. Where is a good attachment point on the front? In particular to be towed out when stuck in the snow.

a simple thick ass piece of steel (minimum 1/4"), ~1.5-2" widex4" long with two holes drilled in it, one on top, one on bottom.

put a strong bolt (min. grade 8 ) through where the factory tow hook used to go and secure with a nut. Put the stock tow hook through the bottom hole and bolt it together like stock.

Should work just fine. The basic idea is you are simply moving the tow hook down a little bit to clear the intake piping.

they are right near the lift pointes a little further out than the aluminum skid plates on either side of the tranny tunnel.

DO NOT USE STANDARD TOW HOOKS you will tear the unibody open. Also never let a tow truck driver hook you from a unibody plug hole. Get down and check that hes putting the EURO HOOKS in the actual holes.

not fit fully inside the bumper again.