In the process of installing the stromung and I was wondering if someone could tell me what hangers they used for their Stromung install, specifically the rear hangers.
The 2 rearmost hangers don't fit properly. The one on the driver side is too close to the muffler, and the one on top won't fit on the hook without the enthusiastic use of a large persuader.
Also, I guess the front hanger (the uber hanger) is not used with the stromung?
TIA
And I've already STFAed (its now a verb).

I used them all, the rears fit fine, the front didn't quite line up at first so I loosened the turbo-downpipe fasteners allowing me to reposition/rotate the downpipe allowing the front hanger to work.

Are your rear hangers rectangular (stock, h-d)? Mine lines up such that the lower hanger contacts the muffler when installed, which might melt it when the muffler gets hot.

turbo, manifold, hoses, d-p, chips are in.
To do:
Hang exhaust
Mount wg / corrugated pipe / intake
injectors
replace aux coolant pump for turbo after run
check everything
cross any fingers I have left and turn key.

My stromung is not centered in the hole on the rear cover either. I was thinking of cutting down the hanger for a better fit, but it's not that important to me.