<center><img src="http://194.87.53.210/imaudivw/VAG02F62.gif"></center><p>
I am cleaning speed sensors (#11) here... The B4 sensors setup is a little bit different, in b3 the speed sensor has a screw to gold it in place, but in b4 it's just plugged in. Rear ones are tough. Can't make them move at all, and with that little room there cant apply enough force to take them out:-(((

Any suggestions?

Don't take them out- first of all, they are abs sensors, not speed sensors.... The rear sensors are super expensive, just like the fronts.. I think they're like $200 or $300 each, also very hard to find used because they usually break while you're trying to pull them out of the hub.

is this another mod you'll put on your list? :)

do they brake in half or what? cause the top black thing was attached very good to the actual sensor body, so even thought its kida a separate piece it didnt brake off, so i just put everything back together:-)

good- cause if you ever break the top you're messed........ There's like 40 feet of tiny wire inside those abs sensors.... The best way to do it is if you heat them up, just the around the hub, then tug a little.... Or you can take the axle out of the rear and you can clean the bottoms of the abs sensors.