Having a Close Look at Air Intake improvements, I came up with this one, but It involves some serious Hole cutting.<br>A small thin scoop that is positioned on the bonnet, that has a hole cut through the bonnet.<br>Then On the Air Box remove the intake Duct.<br>Make a rubber/Foam Seal that sits in between bonnet and air box as a seal.<br>This Will Give good clean/fresh Air that is pushed into the air Box.<br>When It rains You can easily replace the Original Duct still as you have not modified the original ait box.<br>A Further Little mode may be tried by drilling 3 or 4 small holes in the bottom of the the air box,<br>This can drain any water collected and help relieve some excess air due to high speed.<p>Any thoughts on this one? Or buy a second bonnet for modification purposes.

I too took a close look at the airbox / airflow situation when I installed my K&N filter.<br>I was thinking that creating a different headlight<br>setup which eliminated the driving light would allow a straight shot for a good column of air<br>directly at the airbox. On the drivers side you<br>might be able to get more flow to the IC.<br>I'll wait until after the warranty is gone before<br>I play serious re-engineering games though...<p>As a side note, after finding BIG bug carcasses,<br>and a piece of gravel in my airbox, I fashioned a small screen to fit in the front of the intake<br>scoop, its easier to get to to clean....