I saw the pics you have, do you have any other information or pics on attaching the harness to the left side of the drivers seat?

Thanks!

All you need to do it remove the trim piece that is at the bottom near the seat. Take out the back seat, unscrew a few screws (way back) that hold the trim in and gently pull. It will pop out (held in by plastic clips). If you breathe wrong, that silly piece of plastic will crack.

Then, find where the seatbelt anchors in the car (left of driver). Finally, using a 19mm (IIRC) socket or wrench (wrench with a ratchet is best) unscrew the bolt. Insert the metal fitting for the harness along with the seatbelt onto the bolt and reassemble.

go toward the bolt head according to Schroth. And if you age going to put the stock belts back in too, they shoulc go under the Schroth bracket, in other words, between the chassis and the Schroth bracket. But the most important thing is that the bracket's raised head should be in direct contact with the bottom of the bolt head to maintain the designed-in safety features. That's how I did mine and Press's.

If you have any questions, Schroth is at (978)532-1145

Is that what you are talking about?

spread the load.

Mmmm yea. I got massive bolts with some HUGE washers.

;)