what displacement would a combination of boring a 1.8L to 2L and adding a 2L stroker kit yield?

this would be very unpractical but I was just wonderign what someone could end up with if they were as crazy/stubborn as me and had the funds to back it up.
:)

Bore size makes a difference. If you bore out a 1.8t to 2L specs and stroke it using a 2L crank then you end up with a 2 liter motor which is about 1984cc. Now if you increase the bore you will increase the cc.


Then you better call me MR Crazy because I did this 2 years ago to end up with 2033cc.

83.5mm which is 2.5mm over, use this with the stock crank and you come out with a 1.9L motor. Add the 2 liter crank and you end up with with what I have which is 2032cc.

it has a 95.5mm stroke vs 92.8mm of a 2.0

That will get you 2.1L, but I'm sure it would take some work to get it to fit, and custom pistons with the pins moved up.

with just the 2L crank and aftermarket rods.

which has a longer rod, but I'm not sure how much higher you can raise the pin with an ABA piston, you might need custom rods that are slightly shorter.