... have to get to it via the full list though.

- A.

When I was putting the rear deck back, I snapped one of the clips (close to the back of the deck) off. There are three clips that are attached by being stamped into the bottom side of the rear deck. I couldn't think of any way to reattach it except using tape. I'm just hoping now that it won't rattle. So far so good.

Mike

The trick I used was to take a ratchet driver -- you know those screw drivers with the interchangable bits? Remove the bit and you're left use that on the snap-in bolt thingy. A small tap will loosen the bolt.

The bolt in the middle -- which is obscured by the metal bar will need to be played with with a more convential screw driver...

- A.