- Quick Timing Belt question..
- catalytic code
- Serpentine belt tensioner, replace?
- 2.8l engine ignition timing at idle
- Flywheel alignment to crankshaft
- 2000 a6 after run pump?
- APTuning New Years Timing Belt Install Special for Virtually all VW/Audi Models!!!!
- Q 7 Diesel engine problems
- Fuel Injector EXTERNAL leaking. NOT O-RINGS!
- should i put in a surge performence chip
- oil problems
- Fuel sensor issue with 2000/01 A4 Quattro 3.0V6?
- Cd Changer
- Any idea what this part is?
- x-post from b5 a4 forums.
- Fuel sender plug.
- WP locked up and the timing jumped
- Audi F6 (C4) pin data. HELP!!!
- CHRONIC BELT/PULLEY SQUEAKING ON 3.0 A4
- Camshaft seal replacement - small scratch
- Intake Cleaning - Recommendations
- "Throaty, Tractor-Like" Sound when Cold Starting
- Cam chain tensioner
- is there an official 30V thread? engine removal
- Timing Belt, Valve Gaskets, Cam Chain Tensioner Job
- Big oil leak!
- JUST DIED
- vibration at around 1500 revs
- timing belt ?
- ATQ deck height/piston stroke
- Replacement Flexpipe Longevity
- Engine warning light...????
- Stock Spark Plugs Part # Please
- 1999 Audi A6 Q 2.8L Overheats after.......
- 30V Frankenstein
- Sherwin
- Thermostat installation question
- anyone with audi tool 3242...need dimensions asap
- 99 A6 Quattro 2.8 Question.
- engine surge
- APTuning End of Summer Service Specials - Timing Belts, & Alignments!!!!
- 1996 a4 12v swap to 1998 30v
- 2003 3.0 CEL codes
- Water Pump Replacement
- Cylinder Misfire Problem
- Blowing off oil filter after 30 miles?
- Oil pressure sending unit replacement
- VALVE COVER GASKETS
- Red oil pressure warning
- VW in to Audi???
- Vacuum at idle?
- 2.8 shakes when at idle compression is
- How do I get my 2.8 V6 back in time?
- P00021 Intake Cam Advanced
- 1999 A6 2.8 Q fault p1392 Cam Position Sensor
- looping idle
- idle control
- Booster leaking?
- Car won't shift into gear? Perhaps this is the culprit...
- 1992 Audi A4 3.0 Quattro oil problem
- Bank 2 sensor 1
- wtb 3.0 avk vin T and E
- Any thoughts?
- halogen to LED or xenon lights humm?
- radio replacement
- Engine rollers (which rolls, which don't)
- DIY
- Slave Cylinder problem after clutch replacement
- 1998 30v 2.8l Camshaft Alignment
- :: ECS Tuning :: Cam Locking Tool Kit!!
- Timing belt tools
- 1998 2.8 30v a4q cat help
- misfire at all rpm
- different AHA versions?