Well, I lucked out with which wire to cut. Talk about guessing lucky! Shoulda gone on Deal or No Deal! Of course this procedure is available to Audipages if desired.

If you guys have a washer fluid sensor error and its constantly on, even though your fluid level is fine, here is the cheapy fix:

The wire colors are only confirmed for a M.Y. 97



1- Remove passenger side Headlight assembly. (Left hand drive) Left side Headlamp assembly.

2- Locate washer tank pump. The black one is for the windshield and the white one is for your headlight washers.

3- There are 3 wires: Brown, Brown/Blue, Black/Purple. Cut the Brown wire with the blue stripe.

4- Reassemble everything. Make note of where your upper mounting bolt locations are so you do not have to realign your headlights.

You should now have the ability to use the washer pump for the windshield and NOT have the animation go off constantly. The downside is that you won't know when the fluid is low, only when the fluid is out!

If you would like the fluid level sensor function, replace the black pump. It tilts away from the fluid reservoir. I'm not certain that parts sites allow for just the pump, but most likely you will have to purchase the whole assembly.

Gone:


Now:




My custom paddle shifter

* Washer Fluid Sensor Fix

Memory Seat Set Procedure

Current Rides:
2005 BMW 525i - 18" Polished Breyton Flame Wheels

Past Rides:
02 S2000 New Formula Red/Blk
97 A8Q Pearl/Blk ..201K miles!
98 S70 Teal/Tan
here was a rough transition : -)
92 300zx Black/Tan
92 240sx Juniper Grn/Tan
89 Probe GT (first car) White/Red (yuck!)